Part:BBa_K360121

RBS + LovTAP Photosensor + terminator

This photoreceptor was assembled by Strickland et al., and consists of a LOV (light-oxygen-voltage) domain of Avena sativa phototropin1 (AsLOV2) that senses blue light, fused to the trpR- DNA binding domain of the transcription factor trp repressor. The resulting protein is called LovTAP: LOV- and tryptophan-activated protein.

LOV domains bind a flavin-mononucleotide (FMN) or flavin-adenine-dinucleotide (FAD) cofactor, which are used in a wide variety of metabolic pathways as cofactors in redox reactions and are available in most organisms. The cofactor has a broad absorption spectrum, with a maximum at 450 nm. Besides, the core of the LOV domain is often flanked by amino- or carboxy-terminal helices, termed A’α and Jα, respectively.

In the LovTAP construction, AsLOV2 domain via its carboxyl-terminal Jα –helix was ligated to an amino-terminal truncation of TrpR. The resulting protein has a domain-domain overlap with a shared helix. Thus, photoexcitation would change the conformation of the protein, in turn changing the stability of the shared-helix-domain contacts.

Under the presence of light, absorption of a photon leads to the formation of a covalent adduct between the flavin mononucleotide (FMN) cofactor and a conserved cysteine residue in the AsLOV2 domain, which results in conformational rearrangements in LovTAP. This change impacts the affinity of the shared helix for the two domains: disrupting the contacts between the shared helix and the LOV domain and enabling the association of the shared helix with the TrpR domain, which establishes DNA-binding affinity and LovTAP can then bind DNA as an homodimer, repressing the transcription of the genes downstream of its binding sites.

In the dark, when the shared helix contacts the LOV domain, the TrpR domain's DNA-binding affinity decreases and LovTAP is in an inactive conformation.

Sequence and Features

Assembly Compatibility:

• 10
  COMPATIBLE WITH RFC[10]
• 12
  COMPATIBLE WITH RFC[12]
• 21
  COMPATIBLE WITH RFC[21]
• 23
  COMPATIBLE WITH RFC[23]
• 25
  COMPATIBLE WITH RFC[25]
• 1000
  INCOMPATIBLE WITH RFC[1000]

  Illegal SapI.rc site found at 552
  

Design Notes

We decided to synthesize a new LovTap part, that in comparison with the Part:BBa_K191006 that is already at the registry, has the following differences:

1. The 2 PstI restriction sites were removed from the coding region of LovTap.

2. We included a punctual mutation to change the ILE427 by a PHE427, as was proposed by the model [http://2009.igem.org/Team:EPF-Lausanne/Results/Mutations#ILE427_to_PHE results of the team iGEM09_EPF-Lausanne]. With this mutation LovTAP should react faster and the conformational change should be more stable (the protein stays in the active form for longer, under light induction).

The reason of the conformational change is the following:

Cys450 side chain is involved in light state in bond formation with the cofactor. Cys450 can assume two conformational states, called here ON and OFF, and corresponding respectively, to the Sg being near or far from FMN.

The isoleucine 427 is quite big. But not enough to push the cystein's side chain significantly toward the cofactor. So we choose to replace this ILE427 by an PHE427, an amino acid which is much bigger and have more or less the same propreties than the ILE.

3. The stop codon tga was changed for two taa.

4. The part does not include a promoter. We eliminated the inverting regulator sensitive to LacI and CAP protein Part:BBa_R0010. According to the [http://2009.igem.org/Team:EPF-Lausanne/LOVTAP_Results report of EPF-Laussane team ], the expression levels of LovTAP under the inverting regulator, doesn´t seem to show differences to the induction with IPTG. Thus, we decided to remove it and as we know that the [http://openwetware.org/wiki/IGEM:UNAM/2009/Notebook/Modeling_logbook_Claudia/2010/03/12 level expression of LovTAP] must be low, we plan to test weak promoters to choose the best option and include it in the construction.

5. The RBS was changed from a strong Part:BBa_B0030 to a medium strength Part:BBa_B0032, thus expecting lower levels of lovTAP.

Source

LovTAP was assembled by Strickland et al.

References

Strickland, D., Moffat, K., & Sosnick, T. (2008). Light-activated DNA binding in a designed allosteric protein. Proceedings of the National Academy of Sciences, 105(31), 10709. National Acad Sciences. Retrieved from http://www.pnas.org/content/105/31/10709.full.

STRICKLAND, DEVIN. 2009. "NEW APPROACHES TO THE DESIGN OF ALLOSTERIC PROTEINS."