Coding

Part:BBa_K3610003

Designed by: Jonas Sebastian Trottmann   Group: iGEM20_UZurich   (2020-09-01)
Revision as of 19:09, 27 October 2020 by Jtrott (Talk | contribs) (Usage and Biology)


BAK1 Ectodomain from Arabidopsis thaliana

This part is a version of the BAK1 receptor from A. thaliana (Part:BBa_K3610001 for full length) without the intracellular kinase domain and without the native signal sequence.

Usage and Biology

Figure 1: BAK1 ectodomain protein structure (Uniprot Q94F62)


The BRI1-associated receptor kinase (BAK1) is a leucine-rich repeat receptor kinase (LRR-RK) which interacts with multiple other LRR-RKs with different functions in hormone signalling and defense response. BAK1 localizes at the plasma membrane and the endosome. The BAK1 protein forms a structure with an extracellular domain with leucine-rich repeats, a single pass transmembrane domain and an intracellular domain with a kinase function.

Among others, BAK1 interacts with the LRR-RKs EF-Tu receptor (EFR), Flagellin sensing 2 (FLS2) and cold-shock protein receptor (CORE), all of which are pathogen recognition receptors (PRR) in brassicaceae plants. Upon binding of a microbe-associated molecular pattern at the LRR domain of the PRR, BAK1 forms a heterodimer with the PRR which triggers a phosphorylation cascade, leading to upregulation of defense mechanisms.

This part includes only the ectodomain and the transmembrane domain. The intracellular kinase domain was cleaved off. Additionally, the natural signal peptide sequence, which is necessary for localization at the cell membrane in the plant, has been cleaved off as well. Therefore, this part needs to be used together with a signal peptide from the organism in which the protein is expressed.




Plant Immunity Based Biosensing

For visualizing the interaction of BAK1 with other plant receptors the cytoplasmic domain can be replaced with a split fluorescent protein or another protein that generates a visual output. For our iGEM project, we designed a system to use this mechanism for detection of bacterial epitopes in water. We used this part for multiple experiments.

Expression with YFP

We fused this part together with the yellow fluorescent protein venus with a 15 amino acids long linker and added the secretion signal from the alpha-Factor, a protein from S. cerevisiae. The corresponding composite part is Part:BBa_K3610032 (the results for this experiment are also on this parts page). We expressed this protein in S. cerevisiae to test two things. First of all, we wanted to see whether the protein gets expressed at all, and secondly, we were interested in seeing, whether the secretion signal from yeast and the receptor without the intracellular kinase domain would be sufficient for localization at the cell periphery.

In a first step we inserted the single fragments making up this part into a plasmid with a gentamycin-3-acetyltransferase gene and transformed E. coli (DH10alpha) with the plasmids for amplification. In the next step we assembled the fragments in a plasmid with a spectinomycin acetyltransferase and amplified the plasmids again in the same E. coli strain. For this step we applied the techniques of Golden Gate Cloning to get the fragments in the right order into the plasmid. The restriction enzyme we chose was BsaI. For expressing this part consisting of YFP and the receptor protein, we initially intended to use promoters of different strengths to get more quantitative data. Finally, we got the construct in a plasmid with a truncated version of the ADH1 promoter from S. cerevisiae. For termination, this part has the terminator sequence of the enolase 2 protein from S. cerevisiae. The plasmid also contained the TRP1 gene, which encodes phosphoribosylanthranilate isomerase, an enzyme that catalyzes the third step in tryptophan biosynthesis. This enabled us to use the same plasmid for expression in S. cerevisiae. We prepared a medium containing YNB and free amino acids, without tryptophan. S. cerevisiae cells (AP4) were transfected with the plasmid and then plated on the selective medium.

Microscopy

After successful transformation of yeast cells we checked for expression of the protein under a confocal microscope.

T--UZurich--eBAK.png T--UZurich--Control.png

Confocal microscopy confirmed increased fluorescence in the S. cerevisiae cells that had been previously transfected with plasmids containing BAK1 ectodomain fused to YFP. This increased fluorescence indicates expression of our genes. Additionally, this imaging experiment revealed that the fluorescent protein is in part localized at the cell periphery. This is in alignment with our expectations as our construct includes a secretion signal protein and a receptor coding protein with the transmembrane domain. These results suggest that the secretion peptide fused to the receptor ectodomain, including the transmembrane domain can be expressed in S. cerevisiae and that the components are sufficient for localization at the cell membrane.

Spectrometry

In addition to analyzing the cells with a microscope, we conducted a fluorescence assay with a plate reader. We conducted this experiment for multiple receptors at the same time. This way we were able to compare the expression levels of differnt versions of the BAK1 receptor. For each receptor we tried to isolate three different biological samples, however, not all cells grew. Ultimately, we only had two samples for the following S. cerevisiae cells: untransformed (Control), transformed with BAK1 ectodomain fused to YFP (eBAK) and the CORE ectodomain fused to YFP (eCORE). For the BAK1 with and without the native signal peptide fused to YFP (BAK+ and BAK-) and the EFR ectodomain fused to YFP (eEFR), we had samples from three different colonies. For each biological replicate, the optical density at absorbance of 600 nm (OD600) and the fluorescence levels were measured three times.

measured OD600 values (OD)
Replicate 1 Replicate 2 Replicate 3
Blank 0,08200000226 0,08200000226 0,08389999717
Control 0,3806000054 0,3747999966 0,4221999943 0,1316999942 0,131400004 0,1176000014
BAK+ 0,4943000078 0,4638999999 0,4514000118 0,5781000257 0,5253999829 0,5799999833 0,2615999877 0,2171999961 0,2011999935
BAK- 1,417099953 1,365499973 1,368899941 0,6305999756 0,5633999705 0,6216999888 0,896600008 0,7882999778 0,8032000065
eBAK 1,009699941 0,8404999971 0,8934999704 0,2653000057 0,2368000001 0,2592999935
eCORE 1,021499991 0,8616999984 0,9178000093 0,826300025 0,6888999939 0,7401999831
eEFR 1,379699945 1,322700024 1,333500028 1,035899997 1,014000058 0,9526000023 0,4860999882 0,3797000051 0,3829999864

The following settings were applied for fluorescence measurements:

Mode: Fluorescence Top Reading
Excitation Wavelength: 485 nm
Emission Wavelength: 535 nm
Excitation Bandwidth: 20 nm
Emission Bandwidth: 25 nm
Temperature: 22.3°C
Fluorescence Top Reading (FTR)
Replicate 1 Replicate 2 Replicate 3
Blank 1297 1282 1322
Control 2684 2474 2634 1852 1792 1750
BAK+ 3038 2813 2760 2836 2493 2788 2084 2072 2067
BAK- 35794 30319 31424 10792 9097 10517 22609 20227 21220
eBAK 26455 19828 21613 6614 5507 6229
eCORE 10709 8382 9339 8957 7062 7735
eEFR 43125 37782 39589 25641 24668 22517 12410 9054 9027

After measurement of the optical density and the fluorescence, the data were blank corrected (the average of the three blank measurements was subtracted from each measurement value).

The average of each of the three (or two) samples was calculated. From these values, the average was taken again.

After this step, we normalized the fluorescent output for OD600 (FTR/OD). The results of these calculations are displayed in the table below.

Control BAK+ BAK- eBAK eCORE eEFR
4185,221063 9731,614266 26067,19254 28118,24739 3712,946478 23379,84399

If we set the values for the Control to 1 (Control = 1), then we get the fluorescence levels relative to the control, which is again diplayed in the table below.

Control eCORE eEFR BAK- BAK+ eBAK
1 0,8871565975 5,586286516 6,228390841 2,325233033 6,718461693


Figure 3: Fluorescence values standardized for OD600 of the different receptors (C=Control). Cells with BAK+ showed only weak fluorescence, while BAK-, eBAK and eEFR showed a strong increase in the fluorescence levels. CORE did not display any increase when compared with untreated S. cerevisiae cells (autofluorescence).


Results from the plate reader and from confocal microscopy were in alignment. Measurement with the fluorometer suggested increased expression of YFP when S. cerevisiae cells are transfected with a plasmid that contains the BAK1 ectodomain fused to YFP. These results together strongly imply, that the ectodomain of the plant PRR BAK1 from A. thaliana, which has been fused to the secretion signal from the alpha-Factor, is expressed in yeast and also gets localized at the cell membrane.

These discoveries open up many doors for application of plant PRRs in S. cerevisiae.

Expression with split-mCherry

For another part of our project, we fused the ectodomain to the N-terminal domain of the split-mCherry protein instead of YFP. The goal was to coexpress this construct (Part:BBa_K3610032) with one of the plant PRRs that show ligand-dependent interaction with BAK1, like EFR. We managed to design a construct consisting of the ectodomain of EFR which was fused to a secretion signal and the C-terminal domain of mCherry (Part:BBa_K3610039. Coexpressed in S. cerevisiae, these two parts are able to interact upon ligand-binding. This dimerization will reconstitute the functionality of the mCherry protein, leading to a fluorescent output.

Expression with split-NanoLuc

For another part of our project, we fused the ectodomain to the LargeBit part of the split-NanoLuc protein instead of the intracellular kinase domain. The goal was to coexpress this construct (Part:BBa_K3610032) with one of the plant PRRs that show ligand-dependent interaction with BAK1, for example EFR. We managed to design a construct consisting of the ectodomain of EFR which was fused to a secretion signal and the SmallBit of NanoLuc (Part:BBa_K3610043. Coexpressed in S. cerevisiae, these two parts are able to interact upon ligand-binding. This dimerization will reconstitute the functionality of the NanoLuc protein, leading to a chemiluminescent output in the presence of furimazine.

Luminescence Detection

We managed to coexpress the BAK1 ectodomain with LargeBit together with two different receptor ectodomains fused to the SmallBit part of NanoLuc, EFR (eEFR) and CORE (eCORE).

After transfection of S. cerevisiae cells, samples were prepared and examined with a luminometer. We used a plate reader of the type Synergy H1. For a more detailed view on data visite the page of the composite part: Part:BBa K3610038.

Samples were prepared:

  • untransfected control (UT)
  • eEFR and eBAK1 (eEFR)
  • eCORE and eBAk1 (CORE)

each sample type was used for three types of measurements:

  • no bacterial elicitor added
  • csp22 added
  • elf18 added
Results
Figure 1: Average Luminescence Levels over time

As expected the control sample (UT) did not show any luminescence in the presence of the NanoLuc substrate. eBAK1 coexpressed with eEFR showed a strong increase in luminescence. However, the highest levels were recorded in samples without the bacterial epitope elf18. This was unexpected as the epitope elf18 is the known elicitor to induce ligand-dependent interaction between the EFR receptor and its coreceptor BAK1 in A. thaliana. We later repeated the assay with the EFR ectodomain to get more data. Presence of the bacterial epitope elf18 did not lead to an increase in fluorescence levels again.

eBAK1 coexpressed with eCORE showed an increase in luminescence, although the effect was much smaller when compared with eEFR. The results again suggest, that addition of the bacterial elicitor csp22, which initiates interaciton between CORE and BAK1 does not increase the luminescence levels as samples without csp22 added showed greater luminescence than samples which were treated with this bacterial epitope.

These results led us to the conclusion that our plasmids get expressed. It further has been shown that the NanoBit parts fused to the receptors are able to interact and reconstitute their functionality as a funcitonal NanoLuc protein which catalyzes the reaction of furimazine to furimamide, which gives a luminescent output. In our case, however, receptor-specific bacterial epitopes did not increase luminescence levels when the receptors were expressed in S. cerevisiae.

Sequence and Features


Assembly Compatibility:
  • 10
    INCOMPATIBLE WITH RFC[10]
    Illegal PstI site found at 576
    Illegal PstI site found at 621
  • 12
    INCOMPATIBLE WITH RFC[12]
    Illegal PstI site found at 576
    Illegal PstI site found at 621
  • 21
    COMPATIBLE WITH RFC[21]
  • 23
    INCOMPATIBLE WITH RFC[23]
    Illegal PstI site found at 576
    Illegal PstI site found at 621
  • 25
    INCOMPATIBLE WITH RFC[25]
    Illegal PstI site found at 576
    Illegal PstI site found at 621
  • 1000
    COMPATIBLE WITH RFC[1000]


[edit]
Categories
//awards/basic_part/nominee
Parameters
None