Part:BBa_K823001

P_liaI promoter of Bacillus subtilis

P_liaI is the promoter of the liaHI operon of B. subtilis. It has a very low basal activity and is inducible by bacitracin in a concentration dependant manner with a dynamic range over 100-fold.

This fragment does not contain a ribosome binding site.

Usage and Biology

P_liaI is an inducible promoter from B. subtilis which is strongly induced by sublethal amounts of antibiotics that interfere with integrity and biosynthesis of the cell wall [http://www.ncbi.nlm.nih.gov/pubmed/15273097 Mascher et. al., 2004]). In the presence of a suitable stimulus, the two-component system LiaRS is activated. The activated response regulator LiaR binds to the operator of the promoter and induces the transcription of the lia locus. When the promoter is turned on the two proteins encoded by the liaHI operon are expressed [http://www.ncbi.nlm.nih.gov/pubmed?term=Journal%20of%20Bacteriology%2C%20188%20%2814%29%3A%205153%E2%80%935166: (Jordan et al., 2006)]. This promoter is evaluated with the reporters lux as well as lacZ. For more details visit the [http://2012.igem.org/Team:LMU-Munich/Data/Inducible Data] page of the LMU-Munich Team 2012 or get an overview of our whole project [http://2012.igem.org/Team:LMU-Munich Beadzillus].

Evaluation

This part was also evaluated in the publication [http://www.jbioleng.org/content/7/1/29 The Bacillus BioBrick Box: generation and evaluation of essential genetic building blocks for standardized work with Bacillus subtilis] by Radeck et al..

Luminescence measurements

The bacitracin-inducible promoter P_liaI was evaluated in the reporter vector pSB_Bs3C-luxABCDE which contains the lux operon. The promoter activity leads to gene expression and to the production of the protein luciferase. The luminescence produced by this protein can be measured with suitable microtiter plate reader as shown in Fig.1.

Fig. 1: Luminescence measurements of the inducible B. subtilis promoter PliaI after induction with different concentrations of bacitracin. OD600 (up), LUMI (middle) and LUMI per OD600 (down) of two clones (green/blue) depending on the time (h) after induction with bacitracin (0 μg/ml (left) to 100 μg/ml (right)). Data derive from three independent experiments. The graphs show the mean value for three experiments and the standard deviation. Curves were fitted over each other (t=0, OD600=0.3) and smoothed by taking the average of three neighboring values. t=0 is the time of induction.

All clones show a normal growth behaviour up to a bacitracin concentration of 10 μg/ml. At higher concentrations of bacitracin the growth curves decrease because the cells lyse. The promoter P_liaI shows a basal activity of about 10.000 Lumi/OD₆₀₀. After induction with bacitracin the Lumi/OD₆₀₀ increases depending of the concentration of bacitracin. The highest activity of about 1.5 Mio Lumi/OD₆₀₀ can be measured after induction with 10-30 μg/ml bacitracin. To see the induction of this inducible promoter in comparison to an uninducible promoter we also did induction experiments with P_liaG, which should not be inducible by bacitracin. As expected there is no response to the induction with bacitracin and P_liaG shows a constant maximum of about 10.000 Lumi/OD₆₀₀ (Data not shown).

For better demonstration of the P_liaI activity as a function of the bacitracin concentration, data from one timepoint at the experiment (Fig. 1) are shown depending on the bacitracin concentration (Fig. 2). Therefore Lumi/OD₆₀₀ values are shown for the time point t=3,5h.

Fig. 2: Promoter activity of PliaI depending on the bacitracin concentration (0,1 μg/ml to 100 μg/ml). Values of the experiment (Fig. 1) are shown in a different way: Luminescence per OD600 of both clones (blue/green) from the time point t=3.5h. Data derive from three independent experiments.

β-galactosidase assay

The inducible promoter P_liaI was also evaluated with the reporter vector pSB_Bs1C-lacZ. (Fig.3).

Fig. 3: β-galactosidase assay with (grey) and without (black) induction of bacitracin (20 μg/ml) of strains carrying the promoter PliaI fused to lacZ. The average of the β-galactosidase activity (Miller Units) and the standard deviation of two independent clones are shown depending on the time (minutes after induction). This graph shows representative data from three independent experiments.

Promoter activity leads to the expression of the β-galactosidase. The β-galactosidase assay of the inducible Bacillus promoter P_liaI was repeated three times. We induced with bacitracin (20μg/ml) when the cultures reached an OD₆₀₀ of 0.4. P_liaI does not show any activity without induction. After induction with bacitracin there is a strong promoter activity that the produced enzyme reaches an activity of about 500 Miller Units. Summing up, the promoter activity after induction is about 500 times higher than without induction.

Sequence and Features

This part was amplified from the genome of B. subtilis.

Sequence and Features

Assembly Compatibility:

• 10
  COMPATIBLE WITH RFC[10]
• 12
  COMPATIBLE WITH RFC[12]
• 21
  COMPATIBLE WITH RFC[21]
• 23
  COMPATIBLE WITH RFC[23]
• 25
  COMPATIBLE WITH RFC[25]
• 1000
  COMPATIBLE WITH RFC[1000]