Part:BBa_K1033910

fwYellow, yellow chromoprotein

This chromoprotein (also known as FezziwigYFP) naturally exhibits strong color when expressed. Compared to many other chromoproteins, such as amilCP (BBa_K592009), amilGFP (BBa_K592010), spisPink (BBa_K1033932), asPink (BBa_K1033933) and aeBlue (BBa_K864401), the color development is slower. The color is readily observed in both LB or on agar plates after 24-64 hours of incubation.

Usage and Biology

This part is useful as a reporter.

iGEM13_Uppsala: Expression of chromoproteins. The images above show E coli constitutively expressing meffRed BBa_K1033922, aeBlue BBa_K1033929, tsPurple BBa_K1033905, asPink (asCP) BBa_K1033927, fwYellow BBa_K1033910, meffBlue BBa_K1033902, meffRed BBa_K1033922 and scOrange BBa_K1033913.

Sequence and Features

Assembly Compatibility:

• 10
  COMPATIBLE WITH RFC[10]
• 12
  COMPATIBLE WITH RFC[12]
• 21
  COMPATIBLE WITH RFC[21]
• 23
  COMPATIBLE WITH RFC[23]
• 25
  INCOMPATIBLE WITH RFC[25]

  Illegal AgeI site found at 109
  
• 1000
  INCOMPATIBLE WITH RFC[1000]

  Illegal SapI.rc site found at 486
  

Characterization: NWU-China 2019

The NWU-China team overexpressed fwYellow protein in E. coli and extracted and purified. The maximum absorbance was measured in a 96-well plate using a microplate reader (Synergy 2).

Figure 1. fwYellow absorbance spectrum

At the same time, fwYellow can emit strong fluorescence under blue light excitation.

Figure 1. under blue light excitation, The left one is fwYellow

When we used the microplate reader to measure the excitation light and absorbed light, we found that the spectrum of fwYellow is too narrow. Due to the low precision of the instrument, it is impossible to accurately measure its excitation light and emission light. The excitation light is around 522 nm and the emission is about 536 nm.

Characterization: NWU-CHINA-A 2020

Last year, our college team NWU-China did not measure the specific values of fwYellow excitation light and emission light accurately. This year, the NWU-CHINA-A team overexpressed fwYellow protein in E.coli and extracted and purified again.
After 16 hours of fermentation, we added IPTG to overexpress this chromoprotein and continued to cultivate for three hours. Then we centrifuged the broth by High speed freezing centrifuge (4℃,8000rpm,15min). Added the lysis solution according to the ratio of the bacteria’s wet weight to the lysis solution 100mg:3ml, and broke the cells in the ultrasonic cell disruptor(500w, work 3s,Stop 5s, 20min),then centrifuged again to get the protein supernatant (4℃,8000rpm,15min). The wavelength of excitation light and emission light was measured by fluorospectro photometer(F-4700).

Figure.1 under UV excitation, The right one is fwYellow

We scaned the 3D diagrams of samples to read the best conditions: Ex=508nm, Em=510nm.

Figure.2 3D-scan of fwYellow under 400 volt

After that, we measured the excitation and emission spectrum of fwYellow. The scanning range of emission spectrum is 420-530nm, and the scanning range of emission spectrum is 490-600nm.

Figure.3 Excitation spectrum of fwYellow

Figure.4 Emission spectrum of fwYellow

Functional Parameters: Austin_UTexas

BBa_K1033910 parameters

Burden Imposed by this Part:

Burden Value: 0.2 ± 2.4%

Burden is the percent reduction in the growth rate of E. coli cells transformed with a plasmid containing this BioBrick (± values are 95% confidence limits). This BioBrick did not exhibit a burden that was significantly greater than zero (i.e., it appears to have little to no impact on growth). Therefore, users can depend on this part to remain stable for many bacterial cell divisions and in large culture volumes. Refer to any one of the BBa_K3174002 - BBa_K3174007 pages for more information on the methods, an explanation of the sources of burden, and other conclusions from a large-scale measurement project conducted by the 2019 Austin_UTexas team.

This functional parameter was added by the 2020 Austin_UTexas team.

Characterization:Worldshaper-NJBIOX 2022

Group: iGEM Team Worldshaper-NJBIOX Author: Zhiyu Zhang Summary: Characterization of the expression of plasmid pET-29a-fwyellow in Escherichia coli strain BL21

Our team obtained the fwyellow gene from iGem team iGEM13_Uppsala and transformed E.coli strain BL21 with plasmid vector pET-29a-fwyellow. We extracted and purified the fwyellow protein expressed by sonication, ultrafiltration, Ni-affinity chromatography, second ultrafiltration, and boiling. The fwyellow produced was analyzed by bio-information analysis (by SWISS-MODEL), electrophoresis, mass spectrum, and chromatography.

Experiments Results

Proof of successful expression

According to bio-information analysis, the estimated molecular mass of fwyellow is 27.9kDa, which matches the electrophoresis results, as shown below. This phenomenon suggests that fwyellow has been successfully synthesized by the transformed bacteria.

Figure 1. Protein electrophoresis graph

 

Yield:

We had two groups of transformed E.coli. The final yields of fwyellow were 9.66mg/ml and 6.53mg/ml, respectively.

Test of protein characteristics

Molecular mass: The measured mass of fwyellow is 27756.10 Da and 55514.04 Da (dimer). The primary mass spectrum and deconvolution spectrum graphs are shown below.

Figure 2. Primary mass spectrum of complete fwyellow molecule

 

Figure 3. Deconvolution spectrum of complete fwyellow molecule

 

Bio-information analysis

We submitted the primary amino acid sequence of fwyellow to SWISS-MODEL for bio-information analysis. We acquired additional information, such as the structure model, of the protein. The report is shown below.

Figure 4. Structure of fwyellow protein

Figure 5 Bioinformation analysis report of fwyellow