Part:BBa_K590034
FabH2
This part encodes FabH2. The [http://2011.igem.org/Team:Washington 2011 University of Washington iGEM Team] has produced even chain length alkanes using this part and the Petrobrick. In addition, expression of this part and the Petrobrick should theoretically produce branched chain alkanes, but we have not been able to demonstrate this effect, possibly due to the absence of the appropriate substrates in E. coli
Usage and Biology
FabH2 is a FabH homolog fromBacillus subtilis. The FabH family of proteins initiates fatty acid elongation by converting an Acyl-CoA into an Acyl-ACP, with is extended by 2 carbon units to form longer chain length fatty acids. Normally, FabH proteins use a simple 2-carbon acetyl-CoA to start fatty acid biosynthesis, resulting in even chain length, linear fatty acids. However, FabH2 can also use Isobutyryl-CoA and Isovaleryl-CoA, (products from Valine, Leucine, and Isoleucine degradation), resulting in 2-methyl branched fatty acid production[1]. In addition, FabH2 has been hypothesized to start fatty acid elongation with a straight 3-carbon unit (propionyl-CoA), yielding odd chain length fatty acids, which could be converted into even chain length alkanes by the Petrobrick. Expression of FabH2 on the same high copy number constitutive plasmid as the PetroBrick( as in Part BBa_K590030) results in slow cell growth, and low alkane yield( under 10 mg/L vs. approximately 170 mg/L in the Petrobrick).
By moving FabH2 into a low copy number inducible vector(As in The FabBrick) ,we were able to get C14 and C16 alkane production, completing the alkane spectrum from C13 to C17. This is the first time that even chain length alkanes have been recombinately produced.This construct was co-transformed with the Petrobrick in XL1-Blue E. coli. When FabH2 was induced by adding 5uM IPTG, a peak corresponding to the C16 were observed. This was confirmed from the MS spectrum, which had an overall fingerprint consistent with alkane, and a parent ion at a mass of 226, confirming the identity as C16 alkane. In addition, a peak corresponding to the C14 alkane was observed, completing the alkane spectrum from C13 to C17. This is the first time that even chain length alkanes have been recombinately produced. This part requires further optimization in order to further increase total alkane yield( currently at approximately 40 mg/L vs 170 mg/L for the Petrobrick), and to increase the amount of C14/C16 alkane yield, as current yield is only approximately 4 mg/L.
</body> </html>
Functional Parameters: Austin_UTexas
Burden Imposed by this Part:
Burden is the percent reduction in the growth rate of E. coli cells transformed with a plasmid containing this BioBrick (± values are 95% confidence limits). This BioBrick did not exhibit a burden that was significantly greater than zero (i.e., it appears to have little to no impact on growth). Therefore, users can depend on this part to remain stable for many bacterial cell divisions and in large culture volumes. Refer to any one of the BBa_K3174002 - BBa_K3174007 pages for more information on the methods, an explanation of the sources of burden, and other conclusions from a large-scale measurement project conducted by the 2019 Austin_UTexas team.
This functional parameter was added by the 2020 Austin_UTexas team.
Reference
1.Beta-ketoacyl-acyl carrier protein synthase III (FabH) is a determining factor in branched-chain fatty acid biosynthesis. Choi KH, Heath RJ, Rock CO. J Bacteriol. 2000 Jan;182(2):365-70. Sequence and Features
- 10COMPATIBLE WITH RFC[10]
- 12COMPATIBLE WITH RFC[12]
- 21COMPATIBLE WITH RFC[21]
- 23COMPATIBLE WITH RFC[23]
- 25INCOMPATIBLE WITH RFC[25]Illegal AgeI site found at 310
Illegal AgeI site found at 949 - 1000INCOMPATIBLE WITH RFC[1000]Illegal BsaI site found at 355
| None |