Difference between revisions of "Part:BBa K3114015"

Revision as of 08:20, 20 October 2019

Improved RFP coding device - Golden Gate Module Flipper

This is an improvement of part BBa_K1467400

Usage and Biology

This part is a Golden Gate flipper with an RFP device, flanking inverted BsaI sites, and fusion sites compatible with the MoClo assembly standard. This part can be used to convert entire transcriptional units from the Golden Gate MoClo assembly standard into standard BioBricks. It can also be used to convert any BioBrick RFC[10]-compatible vector to a Golden Gate destination vector.

This part has been improved from BBa_K1467400 by substituting the LacI-regulated promoter (BBa_R0010) with a strong constitutive promoter (BBa_J23100). We also exchanged the RBS for a stronger one.

This part allows for colony screening following Golden Gate reactions. Colonies containing the correct assembly should be white in appearance, as the Golden Gate modules will have replaced the RFP device in the vector. Unsuccessful colonies should be red under UV and natural light.

Design

The substitutions that we made in the RFP device were intended to maximize RFP expression and decrease the amount of time required to observe if the colonies are red. The strong constitutive promoter BBa_J23100 and strong RBS BBa_B0030 were chosen because they are very well-characterized.

We also codon optimized this part for high expression in E. coli.

Characterization

iGEM Calgary used this part to convert pSB1A3 to our Golden Gate destination vector. The synthesized sequence was first cloned into linearized pSB1A3 using an EcoRI + PstI digestion and ligation. The product was sequence confirmed. Following this, we successfully used the part as our destination vector to create six genetic constructs via Golden Gate assembly.

We determined the percent successful assembly for our improved part BBa_K3114015 as well as the original BBa_K1467400 based on the proportion of white colonies following transformation of Golden Gate assembly samples. Golden Gate assembly reactions were set up to each contain the same concentration of destination vector and the required DNA inserts in the form of PCR products. A 1:1 insert:destination vector ratio was used in each reaction. They were conducted as per our Golden Gate assembly protocol. BBa_K3114015 and BBa_K1467400 were used in 4-insert assembly reactions using parts:

• BBa_K3114012
• BBa_K3114001
• BBa_K3114006
• BBa_K3114015

The other RFP Golden Gate flipper (BBa_K1467200) that we characterized was used in 2-insert assembly reactions using parts:

• BBa_K3114001
• BBa_K3114006

The Golden Gate assembly products were transformed into E. coli DH5-alpha. Some colonies became visibly red under normal light after 12 hours for the improved part BBa_K3114015 and 18 hours for BBa_K1467400 and the other RFP device Golden Gate flipper (BBa_K1467200) that we characterized. 24 hours after transformation, we counted the number of red versus white colonies for each of the replicates. The results suggest that using the improved RFP flipper BBa_K3114015 resulted in a greater percentage of successful assembly reactions compared to the original RFP flipper BBa_K1467400. However, the reason for this is unclear.

Figure 1. Percent of colonies that are white in appearance 24 hours after transformation for Golden Gate assembly reactions using pSB1A3-BBa_K1467400, pSB1A3-BBa_K3114015, and pSB1A3-BBa_K1467200 as destination vectors. Control reactions were conducted by adding all reagents to the Golden Gate reaction except the DNA inserts. Values represent the mean for three replicates. Error bars indicate standard error of the mean (SEM).

Sequences and Features