Difference between revisions of "Part:BBa K731710"

Latest revision as of 16:29, 11 October 2012

Platform for terminators analysis under the control of tac promoter

This is a platform for the characterization of terminator efficiency by fluorimetric measurements and ratiometric analysis under IPTG inducible tac promoter’s control. It was built starting from BBa_K731700, where the T7 promoter was replaced with the tac promoter by insertion/deletion mutagenesis. The platform has been used for the analysis of T7 wild type terminator's (BBa_K731721) and an E. coli terminator's (BBa_K731722) effects on protein synthesis.

The combined use of BBa_K731710 and BBa_K731700 allows to analyze also any potential difference in terminators' activity due to different RNA polymerases.

Usage and Biology

We made some preliminary analyses to define the best procedure to use this platform. We found that the emission from mVenus was much stronger than the mCherry emission, resulting in some spectral overlap. To improve the quality of the data, off-peak excitation and emission wavelengths were identified that minimized the effect. Therefore, mVenus was excitated at 485 nm (excitation peak is at 515 nm), and the emission of mVenus was collected at its maximum position, i.e. 528 nm. The maximum mCherry excitation wavelength was used (587 nm), but the emission of mCherry was read at 615 nm, as opposed to the maximum at 609 nm. Here is a summary of these wavelengths:

TABLE 1. Standard and modified excitation and emission wavelengths.

This part was used to characterize a T7 wild type terminator (BBa_K731721) and an E. coli terminator (BBa_K731722). These terminators's activity was measured as the ratio between the two proteins' levels using the equation found in literature for termination efficiency. Doing this measurements, however, we realized that terminators can have an effect also on mCherry expression, enhancing it. This effect was previously described Abe. As a consequence of this unexpected outcome, we defined other two parameters that are here summarized in addition to the literature definition of termination efficiency.

The parameters used to analyze the data are:

apparent termination efficiency, calculated with the equation found in literature Nojima,

raw termination efficiency, that does not consider the mCherry contribution

relative increase in the upstream gene expression,

where

-Vs is the A206K Venus peak’s intensity of the construct with the terminator of interest inserted in the prefix-suffix linker

-Vc is the A206K Venus peak’s intensity of the control construct without intervening terminator

-Cs is the mCherry peak’s intensity of the construct with the terminator inserted

-Cc is the mCherry peak’s intensity of the control construct

Measurements

Our experiments exploited an E. coli lysogen strain carrying T7 RNA polymerase and lacIq. Additionally, the cells, i.e. E. coli BL21(DE3) pLysS, also contained a plasmid encoding T7 lysozyme and chloramphenicol resistance. T7 lysozyme is a natural inhibitor of T7 RNA polymerase activity, thus reducing background expression of the target genes. The T7 RNA polymerase is behind a lacUV5 promoter.

FIGURE 2. Results obtained from the in vivo measurements of BBa_K731721 (T7 terminator) and BBa_K731722 (E. coli terminator) using BBa_K731710
The data here analyzed were collected from cells that were expressed for 4 h with 0.1 mM isopropyl β-D-1-thiogalactopyranoside (IPTG). To identify optimal conditions, we screened samples that were and were not sonicated, sample dilutions to decrease the scattering of light, IPTG concentration, time of induction and time after induction. We found that the best results were obtained with induction with 0.5 mM IPTG for 3 h, followed by sonication and centrifugation. The cleared supernatant was then diluted 2-fold with phosphate buffer saline (PBS, 0.0067M PO4 without Ca or Mg, Cat number BE17-516F) and stored overnight at 4 °C. Finally, fluorescence was measured with a Varian Cary Eclipse spectrofluorimeter using emission and excitation wavelengths described above, a slit of 5nm and a voltage of 520V. The samples were left overnight at 4 °C to allow for sufficient time for the fluorescent proteins to properly mature (i.e. protein folding and chromophore formation). Each measurement was made in quadruplicate from different colonies from different transformations and from different plates.

It is worth to highlight that the apparent and the raw transcriptional termination efficiencies, shown in figure 2, are essentially different from both a mathematical and a biological point of view. More specifically, raw termination efficiency is determined just by the expression of the downstream gene, while the apparent termination efficiency represents the variations that occur in the expression of both genes up- and down-stream of the terminator. They are in the same chart just for a comparison purpose.

For more information about the protocol we adopted to take these in vivo measurements, see BBa K731700 and BBa K731710 measurements.

We submitted also this backbone with each terminator used in this study inserted in the cloning region as measurement plasmids; we hope that this could be helpful for anyone who want to verify and further delve into our results. They are BBa_K731711 for the T7 terminator and BBa_K731712 for the E. coli terminator.

More information about the procedure used, the results obtained and our considerations can be found in the [http://2012.igem.org/Team:UNITN-Trento| Trento iGEM 2012 wiki page].

References

<biblio>

1. Nojima pmid=16379390
2. Abe pmid=9150882

</biblio>

Sequence and Features