Part:BBa_K1583110

pRha + Mfp5_CsgA_His fusion protein & pTET + RFP

This part is meant to express a fusion protein of the mfp5 and the csgA gene with His-tag under control of L-rhamnose-inducible promoter. Addionally a RFP coding device was added (BBa_I13521).

CsgA is a protein monomer which can aggregate to form amyloid nanowires in natural biofilms taken from E.coli K-12 MG1655. Inspired by mussels, the Mfp5 (mussel foot protein) has high adhesive properties towards wet polar surfaces. CsgA is a protein monomer which can aggregate to form amyloid nanowires in natural biofilms of E.coli. This protein is transported as an unfolded protein out of the cell. Outside the cell CsgA proteins self-assemble into nanowires after nucleation on the membrane protein CsgB. By creating a fusion protein of Mfp5 and CsgA, the adhesive properties of the mussel foot protein is combined with the formation of nanowires.

The design was based on the paper "Strong underwater adhesives made by self-assembling multi-protein nanofibres" (Zhong et al, 2014).

In order to improve BBa_K1583104 we added BBa_I13521 constitutively expressing RFP. This could be used for both screening for successful transformations, as for visualisation of cells with fluorescent imaging.

Sequence and Features

Assembly Compatibility:

• 10
  COMPATIBLE WITH RFC[10]
• 12
  COMPATIBLE WITH RFC[12]
• 21
  INCOMPATIBLE WITH RFC[21]

  Illegal BamHI site found at 1168
  
• 23
  COMPATIBLE WITH RFC[23]
• 25
  INCOMPATIBLE WITH RFC[25]

  Illegal AgeI site found at 635
  Illegal AgeI site found at 747
  
• 1000
  COMPATIBLE WITH RFC[1000]

Characterization

Three different experiments were done to characterise the BBa_K1583104 biobrick:

• Fluorescence assay
• Crystal Violet assay
• Transmission electron microscopy

As shown in the crystal violet assay in the characterization section of pRha+CsgA & pTet+RFP ((BBa_K1583106)), the RFP conding device does not affect the formation of CsgA protein. Therefore the characterization data of BBa_K1583104 is also valid for this biobrick.

Fluorescence assay

To be able to ensure that CsgA is expressed, we added a gene encoding for GFPmut3 (BBa_I13504) under induction of the same rhamnose promoter (BBa_K1583112) to check that the promoter works. In this experiment, the fluorescence signal of our csgA construct and csgA-GFP (I13504) constructs was recorded in time after induction with no, 0.2% (w/v) or 0.5% (w/v) rhamnose. Besides the fluorescence, the OD600 was measured in order to normalize the fluorescence signal per cell.All conditions were carried out in triplicates to be able to do a statistical analysis on the data. The different experiments were induced in a 96 well plate. The OD600 and fluorescence signal was recorded in a plate reader during a 18 hour period of induction at 30°C.

In figure 1, the fluorescent signal was normalized by the number of cells and plotted as a function of time. The red bars denote the error within each ID.

Figure 1: Fluorescence signal normalized by the number of cells for 0% (w/v), 0.2% (w/v) and 0.5% (w/v) rhamnose with the csgA and csgA-GFPmut3 construct. The error bars are included for all experiments.

As can be seen from figure 1, only the experiments with 0.2% (w/v) and 0.5% (w/v) rhamnose induction with the csgA-GFPmut3 construct gave a clear increase in fluorescence signal in time. All other experiments, gave similar levels of fluorescence, slightly increasing in time. Furthermore, it can be seen that a higher induction level of rhamnose leads to an increase in GFPmut3 and thus fluorescence. Finally, as the fluorescence signal is normalized by the cell density, one can make statements about the activity of the rhamnose promoter. The promoter seems to not be active right after induction, but more after 3 or 4 hours. This is in accordance with data from literature (Wegerer et. al), in which a low amount of fluorescence with a rhamnose promoter was observed after 2 hours of induction.

With this kinetic experiment, we have proven that the rhamnose promoter does indeed induce the expression of the csgA gene.

Crystal violet assay

The assay above showed that the bacteria that we engineered for the project is capable of producing the CsgA proteins after induction with L-rhamnose. However, this did not yet prove that curli are formed. In order to assess whether our bacteria producting the fusion protein of Mfp5 and CsgA can still produce these nanowires, our team adapted the protocol from Zhou et al. (2013) that employs crystal violet (methyl violet 10B) for dying the biofilm-making bacteria that attaches to the surface. In the experiment, our Mfp5_CsgA-producing strain of E. coli was induced at a high (0.5% w/v), low (0.2% w/v) and no (0% w/v) concentration of L-rhamnose. Furthermore, csgA deficient bacteria transformed with an empty plasmid (pSB1C3) were used as control. In the end, the wells were diluted with ethanol so all the content can dissolve in the liquid phase. We measured the absorbance at 590 nm of wavelength for all the samples, obtaining the following results (figure 2.).

Figure 2: Microtiter Plate Assay results for testing biofilm formation. All the measurements were conducted in triplicates. CTRL0, CTRL2 and CTRL5 are E. coli K-12 MG1655 PRO ΔcsgA ompR234 cells with pSB1C3, used as a control. MFP50, MFP52 and MFP55 are E. coli K-12 MG1655 PRO ΔcsgA ompR234 cells expressing a plasmid that contains csgA attached to the mfp5 peptide under an inducible promoter. The termination 0, 2 and 5 denote the induction with no rhamnose (0), 0.2% w/v (2) and 0.5% w/v (5).

To confirm that there is a real change between the analysed samples and the empty plasmid control, a significance analysis was performed for α=0.05 (Table 1.).

Table 1: Significance analysis of the samples analysed, with a significance α value of 5%. All the samples display a significant difference when compared to the empty plasmid homologe sample (CTRL).

Sample	p-value	Significant difference (5%)
CTRL2 & MFP52	0.0043	Yes
CTRL5 & MFP55	0.0016	Yes

The significance analysis shows that cells containing the Mfp5_CsgA_His (BBa_K1583104) biobrick can efficiently create a curli, when compared with an empty plasmid control (i.e. without csgA expression).

Transmission electron microscopy

Using TEM the formation of curli of the biobrick BBa_K1583100 was visualized (Figure 3). Although this is a different biobrick containing only CsgA (compared to the fusion protein of Mfp5_CsgA_His), curli formation can be presumed to be similar for this biobrick suggested by the Crystal Violet assay.

Figure 3: TEM images (magnification 7300 x) of cells containing BBa_K1583100. The left picture shows uninduced cells (0% Rhamnose).The picture on the right shows cells incubated with 1% (w/v) rhamnose.

We did not observe formation of curli nanowires in the uninduced cultures of our strain. However, cells from induced cells clearly produced them, as supported by the TEM images.

Reference

Wegerer, A., Sun, T., and Altenbuchner, J. (2008). Optimization of an E. coli L-rhamnose-inducible expression vector: test of various genetic module combinations”, BMC Biotechnology, 8:2

Zhong, C. et al., 2014. Strong underwater adhesives made by self-assembling multi-protein nanofibres. Nature nanotechnology, 9(10), pp.858–66

Zhou, Kang, Kangjian Qiao, Steven Edgar, and Gregory Stephanopoulos. 2015. “Distributing a Metabolic Pathway among a Microbial Consortium Enhances Production of Natural Products.” Nature Biotechnology 33(4): 377–83.