Part:BBa_J23112

constitutive promoter family member

ATTENTION: This part is a duplicate of BBa_J23103. --mosthege 05:56, 3 April 2015 (CDT)

Variant RFP (au) J23112 1 J23103 17 J23113 21 J23109 106 J23117 162 J23114 256 J23115 387 J23116 396 J23105 623 J23110 844 J23107 908 J23106 1185 J23108 1303 J23118 1429 J23111 1487 J23101 1791 J23104 1831 J23102 2179 J23100 2547

Constitutive promoter family
Parts J23100 through J23119 are a family of constitutive promoter parts isolated from a small combinatorial library. J23119 is the "consensus" promoter sequence and the strongest member of the family. All parts except J23119 are present in plasmid J61002. Part J23119 is present in pSB1A2. This places the RFP downstream of the promoter. Reported activities of the promoters are given as the relative fluorescence of these plasmids in strain TG1 grown in LB media to saturation. See part BBa_J61002 for details on their use.

These promoter parts can be used to tune the expression level of constitutively expressed parts. The NheI and AvrII restriction sites present within these promoter parts make them a scaffold for further modification. JCAraw

Sequence and Features

Assembly Compatibility:

• 10
  COMPATIBLE WITH RFC[10]
• 12
  INCOMPATIBLE WITH RFC[12]

  Illegal NheI site found at 7
  Illegal NheI site found at 30
  
• 21
  COMPATIBLE WITH RFC[21]
• 23
  COMPATIBLE WITH RFC[23]
• 25
  COMPATIBLE WITH RFC[25]
• 1000
  COMPATIBLE WITH RFC[1000]

Note

Parts BBa_J23103 and BBa_J23112 are the same (Rahmi Lale).

iGEM Team 2019 Stuttgart Characterization

We added quantitative experimental characterization to the following biobricks:
BBa_J23100 BBa_J23112 BBa_J23118
These parts are a family of constitutive promoters. They were present in plasmid BBa_J61002. We analyzed the influence of the mentioned promoters on the expression of red fluorescence protein (RFP), both on protein level (fluorescence spectroscopy) and mRNA level using reverse transcriptase quantitative polymerase chain reaction (RT-qPCR).

Biobricks were transformed in E. coli MG1655. Cells were harvested in the early exponential phase and fluorescence was measured. Also, 500 µL of culture was centrifuged and the pellet was used for RNA extraction. In addition to that, E. coli MG1655 was cultured and harvested for RNA isolation without the plasmid BBa_J61002 to ensure, that our primers specifically bind to RFP mRNA.

RT-qPCR was performed and analyzed using the ddCt method. To quantify the expression levels of RFP under different promoters, the cDNA of a house-keeping gene was amplified as well. We chose a GTPase-activation protein (GAP) as a housekeeping gene.


Results of fluorescence spectroscopy

Investigating the grown cell cultures by fluorescence spectroscopy clearly showed emission at 590nm (excitation at 540 nm) indicating a successful expression of RFP. Cells containing the promoter BBa_J23100 showed an emission at 590 nm of 192 +- 13. Compared to that, cells containing the promoter BBa_J23112 showed an emission of 30 +- 1. The highest emission was shown by cells containing the promoter BBa_J23118: 345 +- 4.

Results of qPCR

Figure 1 shows, that RFP expression was about 7-fold higher than the expression of GAP in cells containing promoter BBa_J23100. Compared to that, the expression of RFP in cells containing promoter BBa_J23112 was about 55-fold higher than expression of the house-keeping gene. The highest expression of RFP compared to GAP was observed in cells containing promoter BBa_J23118. Here, RFP expression was 74-fold compared to GAP expression.
Figure 1: Average relative quantification of RFP expression compared to the expression of the house-keeping gene GAP in E. coli MG1655. Cells contained the plasmid BBa_J61002 with different promoters: BBa_J23100, BBa_J23112 and BBa_J23118. As a control E. coli MG1655 were cultivated without the plasmid. RT-qPCR measurements were carried out in technical triplicates. Standard deviation is shown

For more information, detailed material and method description, please visit our wiki

••••• University of Texas at Austin iGEM 2019

UT Austin iGEM 2019: Characterization of metabolic burden of the Anderson Series Description The 2019 UT Austin iGEM team transformed the Anderson Series promoters into our 'burden monitor' DH10B strain of E. coli which contains a constitutive GFP cassette in the genome of the cell. This GFP expression rate fluctuates depending on the number of ribosomes available for the host cell to sustain itself. Using this strain, the relative burden (percent reduction in growth rate) of each Anderson Series part was determined. Our results showed a range of growth rate reductions for each of these parts due to ribosomal reallocation from the genome of the host cell, towards the expression of RFP. Anderson Series parts with strong promoters are depicted with darker red colors and Anderson Series parts with weak promoters are depicted with lighter pink colors to show relative RFP expression. We saw a positive correlation between relative promoter strength and metabolic burden; parts with stronger promoters expressed less GFP and had a lower growth rate than parts with weaker promoters. The regression line for the graph below was constructed by measuring the burden of 5 parts that were created by the 2019 UT Austin iGEM team that each contained an Anderson Series promoter (BBa_J23104 or BBa_J23110), an RBS of varying strength, and a BFP reporter. For more information on characterization of these parts through the burden monitor, visit our team’s wiki page: [1] Fig.1:Growth vs GFP Expression graph showing the relative burden positions of the Anderson Series promoters. The parts with strong promoters are depicted in dark red and are clustered near the bottom of the graph because they have lower growth rates and express lower levels of GFP as a result of high cellular burden. The parts with weaker promoter are depicted in light pink ad are clustered near the top of the graph because they have higher growth rates and express higher levels of GFP as a result of low cellular burden. Table.1: Burden measurements for the Anderson Series promoters measured as percent reduction in growth rate ± 95% confidence interval. Although often we cannot avoid using a specific burdensome part, knowing in advance that it is burdensome, and that it has a high chance of mutating into a non-functional genetic device, can help with troubleshooting and coming up with alternatives. In the specific case of fluorescent protein-expressing devices, Fluorescence-activated cell sorting (FACS) can be used to filter out individual cells that meet a certain fluorescence threshold. This way, the cells expressing lower levels of the fluorescent protein are weeded out of the population.