DNA
epsE 3 IS

Part:BBa_K143006:Design

Designed by: Chris Hirst   Group: iGEM08_Imperial_College   (2008-09-12)
Revision as of 13:02, 12 September 2008 by Chris (Talk | contribs) (New page: <big>'''5' Integration sequence for the EpsE locus of ''B.subtilis'''''</big> <partinfo>BBa_K143006 SequenceAndFeatures</partinfo> ===Design Notes=== The EpsE integration sequences were...)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

5' Integration sequence for the EpsE locus of B.subtilis


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    COMPATIBLE WITH RFC[21]
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    INCOMPATIBLE WITH RFC[25]
    Illegal AgeI site found at 211
  • 1000
    COMPATIBLE WITH RFC[1000]

Design Notes

The EpsE integration sequences were designed from the EpsE (aka YveO) gene's Genbank entry#1 and identification of the sequence directly upstream of the gene on the chromosome (found using NCBI's sequence viewer). The upstream and EpsE gene sequence was analysed for restriction sites and primers (with biobrick prefix and suffix sequences) for two approximately equally sized integration sequences were desgined. The integration sequences were then produced by PCR cloning with Pfu DNA polymerase

Source

The 3’ integration sequence was taken from the B.subtilis chromosome and is homologous to the middle section of the EpsE gene. It was produced by PCR cloning with Pfu DNA polymerase

References

<biblio>

  1. 1 http://www.ncbi.nlm.nih.gov/sites/entrez?db=gene, Gene ID:938633

</biblio>