Problems with PCR using VR/VF2
VR and VF2 (Parts G00101 and G00100 respectively) are used to verify the lengths of parts. While using them to PCR potential parts (S03582 and I13033, both composite parts) for the Registry's Assembly Ladder, I noticed that I was consistently getting excess bands. Contamination was ruled out since the bands still appeared in a Colony PCR. Upon inspecting the sequence of the two parts, I found that each contained regions that the primers could bind, resulting in the shorter bands I was consistently seeing. Since S03582 and I13033 are both composite parts, I determined where exactly the primers were binding to see what parts would be affected during PCR with VR and VF2.
VR Incorrect Annealing
VR can potentially bind B0010 in three different ways. One of the annealing schemes, shown in red in the diagram and below, seems particularly likely. Only 3 of the last 13 bases of VR mismatch to B0010. Also, VR's 3' end would anneal the the part tightly due to the two G - C pairs. The other two possibilities, shown in blue and green, are less likely to occur during PCR. Although the primer may anneal to B0010 in the spots that match, the 3' end of VR does not match closely enough for entension to occur.
VF2 Incorrect Annealing
VF2 can potentially bind R0062 in two different places. Annealing to the segment shown in blue in the diagram seems unlikely to result in extension since there is not any significant pairing near the 3' end of the primer. Depending on the annealing and extension temperatures being used, VF2 may prime from the segment of R0062 shown in red. The binding would not be strong, since the matched bases are mostly A's and T's, but it could be enough to produce the excess bands in the PCR.
