Regulatory

Part:BBa_K1216007

Designed by: Meret Arter   Group: iGEM13_ETH_Zurich   (2013-09-21)
Revision as of 10:36, 24 October 2013 by Blockmoka (Talk | contribs) (Characterization of the pluxR variant dose response to OHHL using plate reader analysis and single cell analysis)

Variant of the wild-type pLuxR promoter with lower sensitivity

BBa_K1216007 is a variant of the wild-type luxR promoter with a lowered sensitivity for LuxR-AHL.

Figure 1. Comparison of BBa_R0062 to the mutant


Sequence and Features


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    COMPATIBLE WITH RFC[21]
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    COMPATIBLE WITH RFC[25]
  • 1000
    COMPATIBLE WITH RFC[1000]


Characterization

The final construct was sequenced.

Site saturation directed mutagenesis of the BBa_R0062 pluxR wild type promoter to obtain the pluxR variant BBa_K2126007

Figure 2.Location of the site directed saturation mutagenesis in the luxbox. As indicated you can see the mutations of the pluxR variant compared to the wild type in red. The positions which were mutated randomly are indicated in red-underlined


Our goal was to achieve mutations in the luxbox of the pLuxR BBa_R0062 promoter to shift the dose response curve of the promoter depending on the OHHL (3-oxo-hexanoyl-l-homoserine-l-lactone) concentration.
We did site directed saturation mutagenisis of specific sites of the luxbox according to literature ([http://www.ncbi.nlm.nih.gov/pmc/articles/PMC2446796/ Luis Caetano A Mutational Analysis Defines Vibrio fischeri LuxR Binding Sites])
We mutated the promoter directly in the BBa_J09855 construct and cloned a eGFP gene as reporter to be able to screen for different dose response curves. In the end we isolate one mutated promoter which shows a shift in sensitivity. For more details see: Characterization of the pLuxR variant dose response to OHHL using plate reader analysis and single cell analysis

Characterization of the pluxR variant dose response to OHHL using plate reader analysis and single cell analysis

Fluorescence data analysis

300-Formulapluxr1.png

The fitting of the following graphs was performed using this equation :

Output = eGFP levels [au]
Top = maximal eGFP level [au]("full induction")
Bottom = minimal eGFP level [au](“leakiness”)
n = Hill coefficient (“cooperativity”)
EC50 = Half-maximal effective concentration (“sensitivity”)
[AHL]=OHHL concentration [nM]


Characterization and comparison to the wild type pluxR using microtiter plate analysis

Figure 3. Sensitivity curve of the wild type promoter and pluxR variant (G1) analyzed on the Tecan M200 Infinity plate reader. The OHHL concentration range is plotted against the standarized fluorescence (au).
For the wild type : EC50=5.86 nM, R2= 0.87,n=1.7
Fore The G1 mutant : EC50=1'341 nM, R2= 0.98,n=0. All assays were carried out in triplicates, results are presented as mean ± standard deviation.

The eGFP reporter allows us to make fluorescence measurement in plate reader experiments as well as in single cell analysis to characterize the promoter behavior depending on [OHHL], by recording the fluorescence [au]. According to literature [http://www.ncbi.nlm.nih.gov/pubmed/18760602 (Geske G.D. Evaluation of a focused library of N-aryl L-homoserine lactones reveals a new set of potent quorum sensing modulators)] we could define the first experimental OHHL ranges to induce the promoter. After some fine tunning and adjusting experiment we could narrow down the ranges to obtain a dose response curve in a reasonable resolution for the BBa_R0062 wild type promoter to the OHHL (3-oxo-hexanoyl-l-homoserine-lactone) concentration. See Figure 3. these data were obtained from a plate reader experiment. According to the sensitivity range of the wild type promoter we could screen for promoters, and scan the potentially shifted sensitivity variants in different ranges of [OHHL]. We finally isolated one promoter variant which shows a shift in sensitivity compared to the wild type. See G1 on Figure 1. The pluxR variant has an EC50=1'341 nM , the pluxR wild type has an EC50=5.86 nM according to the plate reader data. The single cell analysis gave us data of higher quality (see below).

Characterization of the pluxR dose response to OHHL in liquid culture and in agar plates by single cell analysis

To obtain high quality data we did single cell analysis over the range defined above. As expected the EC50 change compared to the microtiter plate data.
See Figure 4.

Figure 4. Dose response comparison between [OHHL] induction in liquid culture and on agar plates, of the BBa_J09855 construct using the pluxR variant BBa_K1216007 promoter and a eGFP gene as reporter</b> analyzed at different [OHHL] in the single cell analysis. The black curve shows the response of to OHHL in liquid culture, the orange curve shows the response to OHHL on agar plates. All assays were carried out in duplicates, results are presented as mean ± standard deviation.


Figure 5. Dose response curve of the pluxR variant G1 on agar plates and liquid culture. The black curve shows the response of to OHHL in liquid culture, the orange curve shows the response to OHHL on agar plates
For the liquid culture we got :EC50=6'482nM, R2=0.97, n=0.8;
For the agar plates we got :EC50=12'555nM, R2=0.93, n=0.8. All assays were carried out in duplicates, results are presented as mean ± standard deviation.

Figure 5 shows the dose reponse curve of the promoter depending on OHHL concentration. We performed this experiment in liquid culture as well as in agar plates (OHHL was added to the melted 1.5% agar), which was closer to our project. We observed a shift in the dose response between the liquid culture (EC50=6'482 nM) single cell analysis and the one in agar plates(EC50=12'555 nM).This correspond to a 2 fold shift.


Comparison of the pluxR variant and pluxR wild type dose response to OHHL in liquid culture and on agar plates

Figure 6. Comparison of the sensitivity of the wild type promoter and the mutated PluxR1 promoter on agar plates
For the wild type we got :EC50=4.45nM, R2=0.80, n=1.7
For the pluxR variant we got: EC50=12'555 nM, R2=0.93, n=0.8. All assays were carried out in duplicates, results are presented as mean ± standard deviation.
Figure 7. Comparison of the sensitivity of the wild type promoter and the mutated PluxR1 promoter in liquid culture
For the wild type we got: EC50=0.02 nM, R2=0.84, n=1.7
For the pLuxR variant we got: EC50=6'462 nM, R2=0.97, n=0.8. All assays were carried out in duplicates, results are presented as mean ± standard deviation.


Figure 6 shows the comparison between the wild type pluxR and pluxR variant dose reponse curve to [OHHL] on agar plates (OHHL was added to the melted 1.5% agar), which was closer to our project. The shift in the dose response between the wild type pluxR (EC50=4.45 nM and the pluxR variant(EC50=12'555 nM) is about 2800 times less sensitive according to the single cell analysis. See Figure 4



Figure 7. shows the comparison between the wild type pluxR and pluxR variant dose reponse curve to [OHHL] in liquid cultures. The shift in the dose response between the wild type pluxR (EC50=0.02 nM and the pluxR variant(EC50=6'462 nM) is about 300'000 times different according to the single cell analysis. See Figure 4


References

(1) M Geske G.D.,Evaluation of a focused library of N-aryl L-homoserine lactones reveals a new set of potent quorum sensing modulators. (2) Luis Caetano A Mutational Analysis Defines Vibrio fischeri LuxR Binding Sites

[edit]
Categories
//promoter
Parameters
None