Coding

Part:BBa_K1123020

Designed by: Ardjan van der Linden   Group: iGEM13_TU-Eindhoven   (2013-09-01)
Revision as of 14:25, 4 October 2013 by ArdjanvanderLinden (Talk | contribs)

Poly(Threonine-Lysine) Protein

This part contains the DNA sequence of a protein of our own design. We first repeated the Threonine-Lysine amino acid pair 6 times to obtain a sequence of 12 amino acids. This sequence was then repeated a total of 36 times. Between these repeats no extra amino acids were added. The idea behind this protein was to provide ourselves with a high concentration of amino acids with amide groups which we could then use to provide CEST contrast in an MRI. The DNA sequence can be placed behind any compatible promoter and the protein will be expressed.

Sequence and Features


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    COMPATIBLE WITH RFC[21]
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    COMPATIBLE WITH RFC[25]
  • 1000
    COMPATIBLE WITH RFC[1000]

Characterization

Characterization by the TU Eindhoven 2013 iGEM Team

This part was designed to generate CEST MRI contrast. The basic principle behind this technique is based on compounds that contain pools of exchangeable protons that can be selectively saturated using radiofrequency irradiation. Upon proton exchange with bulk water, these compounds can be indirectly visualized by measuring the bulk water using an MRI machine. The amino acids Lysine, Arginine, Threonine and Serine contain those exchangeable protons and polypeptides containing those amino acids in abundance are therefore potential contrast agents (see also [http://2013.igem.org/Team:TU-Eindhoven/Background CEST 101]).

The protein of this part has a Lysine percentage of 50 %, which is high compared to other (native) proteins. Therefore, it was expected that this protein would be detectable using CEST MRI.

Methods

The proteins were (aerobically) overexpressed in BL21 using a pET28a vector with a T7 promotor. The bacteria were spun down and fixed in PFA. The entire pellet (bacteria containing our proteins) was then measured in a 7 T Bruker MRI machine. First, the correct water frequency was determined, the machine was shimmed, i.e. a homogeneous magnetic field was created. The first measurement was a T2 weighed image for general orientation. Subsequently local shimming was performed on each of the separate pellets. For the final measurements, the saturation pulse was set to vary from ca. -4ppm to ca. +4ppm (relative to water), the measurements were averaged over 8 separate scans. Also a S0 (without saturation pulse) image was taken.

Results

This data was processed resulting in a asymmetry plot (MTR_assymetric) and a contrast plot visualizing the difference of the sample with the control sample. This was done by both subtracting (absolute difference) and dividing (relative difference). For a complete overview of the processing steps see the TU-Eindhoven 2013 [http://2013.igem.org/Team:TU-Eindhoven/MRIProcessing MRI Data Processing page]. The results are shown below: TU-Eindhoven Parts MRI PTK.png

Conclusion

Around 3.7 ppm is no clear Lysine peak distinguishable. Although in the difference plots there is a high signal at the specific chemical shift, it remains unclear whether this peack is caused by the abundance of Lysines or just background noise. So there is no clear CEST contrast observed yet.


[edit]
Categories
Parameters
None