Part:BBa_K731722

biology rrnBT1 direction Forward forward_efficiency 0.976 +/- 0.005 with T7 RNAP (T7 promoter) 0.985 +/- 0.001 with E. coli RNAP (Ptac)

T1 terminator from E. coli rrnB This is the BBa_B0010 part extracted by PCR from the double terminator BBa_B0015 contained in BBa_E0840. Hence many different teams had problems using BBa_B0010, this is the same part newly submitted, confirmed by sequencing and by experience...ready to use! The characterization of this terminator has been done both with T7 and E. coli RNA polymerases using BBa_K731700 and BBa_K731710 by the 2012 Trento iGEM team.

Examples of Secondary Structures

---

MEASUREMENTS

The characterization of this part was done by the Trento iGEM team 2012 using the new platforms for terminator characterization that they have built and submitted to the Registry as BBa_K731700, BBa_K731710.

Its activity was analyzed both with T7 and E. coli RNA polymerases in vivo and with T7 RNA polymerase in vitro.

The parameters used to analyze the data are:

apparent termination efficiency,

raw termination efficiency,

transcript stabilization effect,

where

-Vs is the A206K Venus peak’s intensity of the construct with the terminator of interest inserted in the prefix-suffix linker

-Vc is the A206K Venus peak’s intensity of the control construct with no terminator

-Cs is the mCherry peak’s intensity of the construct with the terminator inserted

-Cc is the mCherry peak’s intensity of the control construct

In vivo measurements:

FIGURE 1. E.coli terminator's effect on protein expression with two different RNA polymerases
The data shown in figure were acquired in two different days. For each day 4 different replicates were measured at different times. Briefly, BL21(DE3)pLysS were grown in 10 mL of LB until an OD of 0.6 was reached and induced with 0.5 mM IPTG. After 3 hours of induction, 4 separate aliquots of 1 mL were taken and sonicated 3 times for 10 seconds at intervals of 30 seconds. After sonication the samples were diluted 1:3 with PBS 1x directly into a cuvette and incubated overnight at 4C. Fluorescence measurements were taken with a Cary Eclipse Varian fluorimeter with a window ranging from 450 nm to 700 nm using the following excitation and emission wavelengths.

In vitro measurements:

FIGURE 1. E.coli terminator's effect on in vitro protein synthesis with the T7 RNA polymerases
Cell free measurements were done with the PurExpress kit from New England Biolabs, using 250 ng of DNA previously purified by ethanol precipitation, following the protocol suggested by the manufacturer. Measurements were done with a PTI fluorimeter using the following excitation and emission wavelengths.

More information can be found in the iGEM Trento 2012 wiki page.