Not Released
Experience: Works
Not Used
Get This Part
Coding

Part:BBa_K731480

Designed by: Andrea Tassinari, Francesco Guzzonato   Group: iGEM12_UNITN-Trento   (2012-08-22)
Revision as of 22:55, 6 September 2012 by Cridelbianco (Talk | contribs) (Usage and Biology)

IPTG Inducible sfGFP tagged Cysteine desulfhydrase (CysDes)

A sfGFP tagged CysDes inducible by IPTG.

This part encodes a cysteine desulfhydrase (CysDes) from Treponema denticola (BBa_K731600) downstream of a strong expression IPTG inducible cassette (BBa_K731300) in the pSB1C3 backbone. When transformed in E. coli strain NEB10b and induced with IPTG this biobrick produces an enzyme converting L-cysteine into hydrogen sulfide, pyruvate and ammonia.

ATTENTION: When using this part special handling and precaution should be taken, as this enzyme produces H2S. Manipulation of cells producing this part should be done under a chemical hood.

This part was cloned by the iGEM Trento 2012 team for the creation of an aerobically engineered pathway for the removal of the black crust disfiguring marble stones. Further information about this part and its characterization can be found in the iGEM Trento 2012 wiki page.


Usage and Biology

CysDes is a unique 45 KDa hemolysin cysteine dependent, that was shown to have also aminostransferase activity. (1, 2) The enzyme catalyze the degradation of L-cysteine to produce hydrogen sulfide, ammonia and pyruvate.

This part produces high levels of CysDes enzyme upon IPTG induction. Protein expression levels have been monitored with the sfGFP tagged composite part BBa_K731480.

Part BBa_K731400 has been fully characterized in psB1C3 and also in the low copy vector psB4K5 using E.coli strain NEB10b.

SAFETY NOTES Please note that this part produces hydrogen sulfide, which is toxic if inhaled in high concentrations. Cells handling should be done under a chemical hood. A safety handbook on the use of H2S producing bacteria is posted on the Trento 2012 wiki.


AT1480 1.jpg

FIGURE 1. Protein expression and cell growth upon IPTG induction NEB10b cells transformed with BBa_K731480 were grown in LB at 37C until OD of 0.7 and induced with different concentrations of IPTG. After 4 hours a 1.5 mL aliquot was taken from each sample. Cells were span down and resuspended in 1.5 mL of PBS. Panel A: Fluorescence measurements were taken with a Varian Cary Eclipse Spectrophometer using an excitation wavelenght of 464 nm. Panel B: Optical density at 600 nm.


AT1480 2.jpg

FIGURE 2. Effect of glycerol and glucose on protein expression levels. Cells were grown at 37C in LB until it was reached an OD of 0.4. The cells were at this point span down and resuspended in an equal volume of MOPS medium and allowed to grow to an OD of 0.6. Prior induction the cells were splitted into two samples of equal volume and one of the two sample was induced with 0.1 mM IPTG. After 4 hours a 1.5 mL aliquot was taken to measure fluorescence intensity. The assay was performed always in the presence of 1 mM L-cysteine and in two different MOPS media. MOPS A: 60 mM glycerol (yellow). MOPS B: 30 mM glucose (blue). The experiment has been performed in triplicate.

AT1480 3.jpg


FIGURE 3. Effect of cysteine on protein expression levels. Cells were grown at 37C in LB until it was reached an OD of 0.4. The cells were at this point span down and resuspended in an equal volume of MOPS medium and allowed to grow to an OD of 0.6. Prior induction the cells were splitted into two samples of equal volume and one of the two sample was induced with 0.1 mM IPTG. After 4 and 8 hours of induction a 1.5 mL aliquot was taken to measure fluorescence intensity. The assay was performed in the presence and in the absence of 1 mM L-cysteine and two different media: MOPS A 60 mM glycerol (yellow), MOPS B 30 mM glucose (blue).


AT1480 4.jpg

FIGURE 4. CysDes toxicity test by optical density and serial dilution. Cells were grown under the same conditions described as before. At 4 and 8 hours of induction a 500 ul sample was taken from the uninduced and the induced culture and used to make serial dilutions ranging from 1:100 up to 1:10ˆ6. A 200 ul aliquot of each serial dilution was plated on LB agar and placed overnight at 37C. The following day the number of colonies from each plate were counted. Conditions used are MOPS with 60 mM glycerol (colore) and MOPS with 30 mM glucose (colore). All experiments were done in the presence of 1 mM cysteine. Panel A: Optical density at different time points in MOPS A (A) and B (B). Colonies Forming Unit (CFU) at 4 hours and 8 hours in MOPS A (C) and MOPS B (D).

References

1. INFECTION AND IMMUNITY, Nov. 1995, p. 4448–4455
2. Appl Microbiol Biotechnol (2003) 62:239–243

Sequence and Features


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    INCOMPATIBLE WITH RFC[21]
    Illegal BamHI site found at 2460
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    INCOMPATIBLE WITH RFC[25]
    Illegal NgoMIV site found at 1559
  • 1000
    INCOMPATIBLE WITH RFC[1000]
    Illegal SapI.rc site found at 2490


[edit]
Categories
Parameters
None