Regulatory
BS

Part:BBa_K566002:Design

Designed by: Daniel Rodriguez, Porfirio Quintero   Group: iGEM11_UANL_Mty-Mexico   (2011-09-26)
Revision as of 16:43, 27 September 2011 by Quintero (Talk | contribs) (References)

Biphasic switch


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    INCOMPATIBLE WITH RFC[21]
    Illegal BglII site found at 95
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    COMPATIBLE WITH RFC[25]
  • 1000
    COMPATIBLE WITH RFC[1000]


Design Notes

Distance between pRM and OL must be longer than 1.6 kb due to necessity of loop formation for more effiecient repression state of the switch.


Source

Extracted directly from Lambda genome by separate as pRM and OL parts, constructed by classic BioBricks system.

References

1. Dodd BI, Perkins AJ, Tsemitsidis D, Egan BJ. (2001) Octamerization of CI repressor is needed for effective repression of PRM and efficient switching from lysogeny Gene Dev, 15:3013–3022. 2. Révet, B., von Wilcken-Bergmann, B., Bessert, H., Barker, A., and Müller-Hill, B. (1999) Four dimers of repressor bound to two suitably spaced pairs of operators form octamers and DNA loops over large distances. Curr. Biol. 9:151–154.

Further reading: - Isaacs FJ, Hasty J, Cantor CR, Collins JR (2003) Prediction and measurement of an autoregulatory genetic module Proc Natl Acad Sci USA, 100:7714-7719. - Michalowski CB, Short MD, Little JW (2004) Sequence tolerance of the phage λ PRM promoter: implications for evolution of gene regulatory circuitry J Bacteriol, 186:7899-7999. - Court DL, Oppenheim AB, Adhya LS (2007) A New Look at Bacteriophage λ Genetic Networks. J Bacteriol. 189:298–304. - Voigt AC. (2006) Genetic parts to program bacteria Curr Opin Biotechnol, 17:548–557.