Generator

Part:BBa_K1060009

Designed by: Ingmar Claes, Su Wang, Sylvie Weckx   Group: iGEM13_KU_Leuven   (2013-09-19)
Revision as of 00:20, 29 October 2013 by RobbertBoudewijns (Talk | contribs) (System testing)

Medium constitutive expression of EBF synthase from Artemisia annua

For the production of the alarmhormone,(E)-β-farnesene, a sesquiterpene synthase gene (GenBank Accession No. AJ271793) was put behind a medium (constitutive) promoter and medium RBS (BBa_K608006).


Sequence and Features


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    INCOMPATIBLE WITH RFC[12]
    Illegal NheI site found at 7
    Illegal NheI site found at 30
    Illegal NheI site found at 177
  • 21
    INCOMPATIBLE WITH RFC[21]
    Illegal BglII site found at 1368
    Illegal BamHI site found at 677
    Illegal XhoI site found at 639
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    COMPATIBLE WITH RFC[25]
  • 1000
    INCOMPATIBLE WITH RFC[1000]
    Illegal SapI.rc site found at 249


Construct digestion

BBa_K1060009_gel_pic.jpg


Characterization of BBa_K1060009

BBa_K1060009.jpg

E. coli BL21(DE3) strain

Mg2+: 5mM

control: BL21(DE3) without plasmid and antibiotics

System testing

Our pilot experiment with aphid indicated that our brick performed the desired function, for the video of aphids experiment, please go to [http://www.youtube.com/watch?v=n-pMp8-XdUo Aphid Repellence video].
In this video you will find our first behavioural experiment with aphids. An EBF-producing bacterium plate (E. coli BL21(DE3)) on LB with 5mM Mg2+ and Chloramphenicol is placed on the left, a control plate on the right, aphids are placed on the leaf in the middle. The first results indicate a positive trend, as we can see them moving from left to right. (You may have to watch the video in full screen to clearly see the aphids.) For more information on the experimental setup and a discussion of the results go to [http://2013.igem.org/Team:KU_Leuven/Project/Glucosemodel/EBF#aphid%20experiments here].

For more information see the experience page or go to [http://2013.igem.org/Team:KU_Leuven/Project/Glucosemodel/EBF#aphid%20experiments here].

To back up our pilot experiment, quantitative analysis of aphid experiments was conducted. Three biological repeats for both a control setup (BL21 wild-type) and our EBF producing strain were used. Three infested leaves with similar size were placed in glass container for each setup, and the bacteria plates were only introduced 1 hour later (when the aphids were settled down on the leaves). The amount of aphids on top of the leaf as well as the amount of moving aphids were counted every 30 minutes. We observed a trend of more aphids scattering away from the leaves in the EBF setup but no statistical differences were seen in the control group, which proved that aphids were more agitated in the EBF setup compared to the control.

Error creating thumbnail: Invalid thumbnail parameters
Error creating thumbnail: Invalid thumbnail parameters

SDS-PAGE confirmation

As another approach to prove our constructs (BBa_K1060009, BBa_K1060011 and BBa_K1060014), we transformed our different EBF synthase bricks in an E.coli expression strain, grew these up under different temperatures, times and, if possible, IPTG induction levels. Bacterial pellets were harvested and proteins extracted.
Here we showed the most interesting results. The figure shows some slight additional bands in lane a (around 110kDa and around 60 kDa), the protein extract from the lacI operator medium strength promoter construct. These bands are less clear in the medium and high strength promoter lane. The expected size of the EBF synthase protein is around 66kDa which could fit with the lower band. Gel extraction and Mass Spectrometry based identification will confirm if these bands represent the EBF synthase gene and possibly the increased production of a secondary protein. Interestingly, the lacI medium promoter construct did not influence aphid behaviour. Possibly the expression of EBF synthase is just too high, which would be equally inhibitory as a too low concentration. Other approaches to better identify the functionality of this construct would be via a gas chromatography analysis to directly measure the amounts of EBF produced.

EBFS protein.JPG

In the figure below, we showed further characterizations: MgCl2 was added to the growth medium as it is suggested to improve solubility and functionality of EBF Synthase. We transformed BBa_K1060009 into DH5a and BL21(DE3), with/without MgCl2. Simultaneously we took an "empty" strain as a control, again with/without MgCl2. We grew overnight cultures of these 6 strains, inoculated 50ml each to a final Optical Density (600nm) of 0.05 and followed cellular growth over time (Growth curve figure). Simultaneously, we took samples for protein extraction at the OD600nm's indicated in SDS-PAGE figure. The growth curves showed that DH5a, transformed with BBaK1060009, had growth issues, irrespective of the presence of MgCl2. Interestingly, these cells showed an additional band around 50kDa (SDS-PAGE figure) which was not observed in the BL21(DE3) transformed strains (data not shown) nor the control strain (SDS-PAGE figure). Theoretical predictions suggest the EBF Synthase product should run around 66kDa, yet this still needs to be proven. (More details refer to [http://2013.igem.org/Team:KU_Leuven/Project/Glucosemodel/EBF here])

Protein oct28.JPG
Growthcurves EBFS.JPG
[edit]
Categories
Parameters
None