Part:BBa_K554002:Experience
HlyA secretion signal peptide
This part was used to [http://2011.igem.org/Team:UNICAMP-EMSE_Brazil/Results#Device_3_testing.2C_Protein_Secretion_System Device 3 testing, Protein Secretion System]
Device 3 testing, Protein Secretion System
The assembled devices related to secretion system (Hemolysin secretion system under control of SoxS – SoxS-HlyB-HlyD-TolC) was tested under laboratory conditions using GFP as reporter.
Methods
To access GFP secretion, competent E. coli DH5α strain cells were transformed simultaneously with a pSB1C3 vector (Chloramphenicol resistant) carrying both the sensor (Strong_Constitutive_promoter + RBS + SoxR + Terminator) and the effector (SoxS_promoter + RBS + GFP + HlyA + Terminator), and pSB1AK3 (Ampicillin resistant) carrying the secretion system (SoxS_promoter + RBS + HlyB + HlyD + TolC + Terminator). As a non-secretion control, E. coli harboring only the pSB1C3 vector with both sensor and effector systems was used.
Oxidative stress was induced by adding increasing concentrations of Paraquat (Methyl viologen dichloride hydrate - Sigma), an oxidative stress inducer in bacteria. The secretion was tested in cultures harboring A) and B) (Figure ) using 0 μM and 40 μM of Paraquat as described [http://2011.igem.org/Team:UNICAMP-EMSE_Brazil/Results#Methods above]. After 3 hours samples were collected, centrifuged (4000 rpm / 10 min; to avoid cell lysis) and the supernatant was collected and centrifuged again (13000 rpm / 10 min; to remove remaining cells). The supernatant fluorescence was measured in fluorometer (SLM – Aminco; 4 nm bandpass and 10 mm) with excitation in 500 nm and emission spectra from 508-550 nm. The GFP fluorescence was also detected in cells by fluorescence microscopy (Olympus).
Results
GFP secretion was confirmed by fluorescence emission and estimated to be approximately 6% of total protein, according to fluorescence levels. Significant levels of GFP fluorescence were found only in the supernatant of Paraquat induced cultures containing both the sensor/effector and the secretion systems but not in the non-induced cultures and in the cultures containing only the sensor/effector system (Figure 2).
In the black line we have our control, bacteria with the complete secretion system and without paraquat added. You see low fluorescence levels. The red line represents the culture induced with 40uM paraquat, with the fluorescence peak at 511nm. In order to check it this fluor. Peak is due to na artifact such as cell lysis we tested the cultures without secr. System with paraquat added. We saw no fluor. Peak and we may conclude that the observed for red is really due to GFP secretion.
From Figure 2,
User Reviews
UNIQd5a4bb1712534475-partinfo-00000000-QINU UNIQd5a4bb1712534475-partinfo-00000001-QINU