DNA

Part:BBa_K3905017

Designed by: Peter Heywood   Group: iGEM21_City_of_London_UK   (2021-10-07)
Revision as of 22:56, 21 October 2021 by Hweiniger (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)


517-5 T7p* Probe 1

This is one of the two probes required for the isothermal amplification of miR-517-5p.

How our miRPA works


As seen in the diagram above, two DNA probes, one with 5’ phosphorylation, bind to the miRNA, and are ligated together by DNA ligase. Then, primers are added, with DNA polymerase, and complementary strands to the ligated probes are synthesised. Then, RPA can take place: primers, associated with recombinase protein so they can dislodge the strands, replicating them in a similar method to PCR, but as no heat cycles are required to break up the strands, the process can take place isothermally.


In order for the miRNA to be detected, we decided to use ‘asymmetric RPA’: an excess of forward primers are added (usually 5x the amount), so an excess of the strand that was originally miRNA form, so there is now ssDNA with the miRNA code in DNA. This can be detected by our toehold switches.




Characterisation

Introduction

To show that miRPA can amplify our miRNA whilst discriminating between our desired miRNA and homologous miRNAs, we tested our trigger miRNA with their respective closest homologs, as determined by our software tool.

Methodology

We ordered our probes and primers on IDT and then resuspended them in a TE buffer and added them to our trigger and homologous miRNAs, with DNA ligase to bind the probes together. We amplified the miRPA product with PCR. We then ran a gel electrophoresis on the miRPA products.

Results

We did not have access to gel ladders which could discriminate between <100bp DNA strands, but our gel showed that the target miRNA, miR-517-5p was amplified and more so than the homologs. Furthermore, the fact that the homologs moved further through the gel suggested that the probes had not bound together, which would suggest the probes and homologous RNAs did not bind together.

Conclusion

Using miRPA in our test would allow us to ensure there is an adequate miRNA concentration, and our characterisation of the technique showed it is specific to our miRNAs.

Sequence and Features


Assembly Compatibility:
  • 10
    INCOMPATIBLE WITH RFC[10]
    Illegal XbaI site found at 4
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    COMPATIBLE WITH RFC[21]
  • 23
    INCOMPATIBLE WITH RFC[23]
    Illegal XbaI site found at 4
  • 25
    INCOMPATIBLE WITH RFC[25]
    Illegal XbaI site found at 4
  • 1000
    COMPATIBLE WITH RFC[1000]


[edit]
Categories
Parameters
None