Part:BBa_K2491025:Experience

This experience page is provided so that any user may enter their experience using this part.
Please enter how you used this part and how it worked out.

Applications of BBa_K2491025

Degradation of Fluorene This shows the proof that this sequence works as intended: to degrade Fluorene. (For the Silver Requirement) Clones were named differently throughout the experiment.

Clone 48: K2491013

Clone 51: K2491025 (What the Page is About)

Clone 54: K2491026

EXPERIMENTAL DESIGN In order to assess whether the newly engineered E.coli strains containing either the fluorene catabolic pathway was able to degrade their respective PAH, they were grown in minimal medium supplemented with fluorene or phenanthrene as a sole source of carbon. For controls, the strains were grown in presence of glucose. In addition, E.coli strains containing the corresponding vector without insert was also grown in parallel. Fluorene was prepared as stock solution of 10 mg/mL and was initially dissolved in methanol. Because the stock solution showed a slight precipitate, stock solutions of 10 mg/mL was also prepared in the organic solvent dimethyl sulfoxide (DMSO). Growth comparisons using these 2 solvents were performed in parallel.

CULTURE SETUP Cultures were started from glycerol stock in 4 mL of medium and incubated at 37°C. The OD readout of the overnight cultures was determined using a spectrophotometer according to the protocol shown above. All cultures were then diluted to 0.02 using the volume below and OD measurements were determined at the indicated time points.

The data show all absorbance measurements obtained during the biotransformation of fluorene by our recombinant E.coli in minimal medium supplemented with PAHs. To evaluate whether the recombinant cells had the ability to transform PAHs, growth experiments were set up with various clones expressing the fluorene catabolic pathway. The clones described above with the catabolic pathway under the control of 3 different constitutive promoters were set in cultures using minimal medium supplemented with fluorene (0.1 mg/mL) as sole source of carbon (figures below). Antibiotics were added as appropriately. Clones containing the catabolic pathway exhibited higher cell density at 48 hours compared to their respective controls (vector alone) with the strongest promoter given a greater advantage (clone 48 or K2491013 for fluorene). PAHs dissolved in DMSO appeared slightly more available than PAHs dissolved in methanol. This may be explained by the fact that PAHs stock solutions prepared in methanol exhibited some precipitates not observed with DMSO-based stocks.

Figure 1. Growth of recombinant E.coli BL21DE3 cultures harboring the control plasmid pSB3T5 or the fluorene pathway under the control of 3 different constitutive promoters: BBa_J23100 (clone 48), BBa_J23101 (clone 51), and BBa_J23110 (clone 54) cloned into pSB3T5. Data points represent value averages of duplicate of OD at 600 nm taken over time for 2 independent colonies per clone. Recombinant clones were grown in minimal medium supplement with tetracycline (15 µg/mL) and fluorene (0.1 mg/mL). Fluorene was dissolved in 100% DMSO (Top panel) or 100% methanol (Bottom panel).

Growth comparison of recombinant E.coli in minimal medium supplemented with PAHs and glucose. In order to evaluate the role of toxicity and/or the metabolic burden caused by the PAH catabolic genes and the PAHs, namely fluorene and phenanthrene, cells were grown in minimal medium together with fluorene or phenanthrene and glucose as carbohydrate sources (figures below). It appears that all 3 clones carried by a low copy plasmid number with the fluorene catabolic pathway under the control of 3 promoters of various strengths behaved similarly to the control strain harboring the corresponding vector pSB3T5 with no insert. The fluorene genes independently of their expression level do not appear to impact cell growth when carried by a low copy vector. In addition, fluorene (0.1 mg/mL) in presence of glucose is not toxic to the cells. It appears that all 3 clones carried by a high copy plasmid number with the phenanthrene catabolic pathway under the control of 3 promoters of various strengths behaved differently to the control strain harboring the corresponding vector pSB1C3 with no insert. The phenanthrene genes independently of their expression level appear to impact cell growth at least during the initial phase. Phenanthrene (0.1 mg/mL) in presence of glucose does not appear to be toxic to the cells as the control cell grew.

Put Graphs of Growth Here

Figure 3. Fluorene biotransformation experiment using recombinant E.coli BL21DE3 harboring the control plasmid pSB3T5 or the fluorene pathway under the control of 3 different constitutive promoters: BBa_J23100 (clone 48), BBa_J23101 (clone 51), and BBa_J23110 (clone 54) cloned into pSB3T5. Data points represent value averages of duplicate of OD at 600 nm taken over time for 2 independent colonies per clone. Recombinant clones were grown in minimal medium supplement with tetracycline (15 µg/mL), fluorene (0.1 mg/mL), and glucose (0.4%).

EXPERIMENTAL DESIGN

This study was aimed at determining the growth rate of the recombinant strains containing the fluorene catabolic pathway alone or together when using fluorene as sole source of carbon. Recombinant cells were grown in minimal medium supplemented with fluorene as a sole source of carbon. For controls, the strains were grown in presence of glucose. In addition, E.coli strains containing the corresponding vector without insert was also grown in parallel. PAHs were dissolved in DMSO.

CULTURE SETUP

Cultures were started from glycerol stock in 4 mL of medium and placed at 37°C. The OD readout of the overnight cultures was determined using a spectrophotometer according to the protocol shown above. All cultures were then diluted to 0.02 using the volume below and OD measurements were determined at the indicated time points.

Put Pictures of Graphs

Graph 3. Average absorbance values measured in quadruplet at 600 nm of cultures of 2 independent colonies of control (vector) and catabolic plasmid (clone CCA-48 or K2491013 for fluorene) at 2, 4, 24, and 48 hours after inoculation of minimal media supplemented with fluorene at 0.1 mg/mL with or without glucose (0.4%) at 25. All media contained the surfactant Tween-20 (0.1%). Cultures were grown at 25°C or 37°C. MM= Minimal Medium, Glu= Glucose; Ave.= Average; OD=Optical Density; SD= standard deviation.

User Reviews

UNIQ72ebb18fde8c2d99-partinfo-00000000-QINU UNIQ72ebb18fde8c2d99-partinfo-00000001-QINU