Plasmid

Part:BBa_K802004

Designed by: Sandu Ioana   Group: iGEM12_Lyon-INSA   (2012-09-20)
Revision as of 15:21, 26 September 2012 by Agnès (Talk | contribs) (Antibiotic resistance)

Shuttle vector for E. coli and B. subtilis

This part is a shuttle vector of 6.5kb which is Ampicillin resistant in E. coli and Erythromycin resistant in B. subtilis. It is a high copy number plasmid in both B. subtilis and E. coli. It has a polylinker containing all 4 of the iGEM restriction sites.




Assembly Compatibility:
  • 10
    INCOMPATIBLE WITH RFC[10]
    Illegal prefix found in sequence at 6506
    Illegal suffix found in sequence at 1
  • 12
    INCOMPATIBLE WITH RFC[12]
    Illegal EcoRI site found at 6506
    Illegal NheI site found at 3377
    Illegal SpeI site found at 2
    Illegal PstI site found at 16
    Illegal NotI site found at 9
    Illegal NotI site found at 6512
  • 21
    INCOMPATIBLE WITH RFC[21]
    Illegal EcoRI site found at 6506
  • 23
    INCOMPATIBLE WITH RFC[23]
    Illegal prefix found in sequence at 6506
    Illegal suffix found in sequence at 2
  • 25
    INCOMPATIBLE WITH RFC[25]
    Illegal prefix found in sequence at 6506
    Illegal XbaI site found at 6521
    Illegal SpeI site found at 2
    Illegal PstI site found at 16
  • 1000
    INCOMPATIBLE WITH RFC[1000]
    Illegal BsaI site found at 3203
    Illegal BsaI.rc site found at 5190



Characterization

Transformation yield

In E. coli NM522 strain, the average yield was 3.3 x 106 cells/µg.The transformed cells were selected on LB medium supplemented with Ampicillin at a concentration of 100µg/mL.

In B. subtilis 168 strain, the maximum yield was 70 cells/µg. The transformed cells were selected on LB medium supplemented with Erythromycin at a concentration of 15µg/mL.

Antibiotic resistance

Given the fact that this shuttle vector is very similar to BBa_K802003, the two of them were tested in parallel. Two experiments were made in order to characterize the antibiotic resistance of the shuttle vectors : the first one on Agar plates and the second one in liquid cultures. In both cases the medium was LB supplemented with Ampicillin at different concentrations.


E. coli tests

The shuttle vector was transformed into NM522 strain in order to be tested.

A) Agar plates
Saturated cultures containing the shuttle vectors were diluted 10, 100, 1,000 and 10,000 times. A volume of 5 µL of each solution containing the strain with the part BBa_K802003 (the saturated culture and the 4 diluted solutions) was spoted on the plate. The volume of the cultures containing the second shuttle vector (BBa_K802004) was adjusted regarding OD600 in order to spot approximately the same number of bacteria.









BK37 stands for the NM522 strain transformed with BBa_K802003 (left side of each plate) and BK38 stands for the NM522 strain transformed with BBa_K802004 (right side of each plate)













As it can be seen on the picture, at 10 mg/mL (i.e. 100 times the usual selective concentration) there is bacterial growth, even for the culture diluted 10,000 times (the corresponding inoculum is indicated by the number 4 written on the plates on the picture)


B) Liquid cultures

Multiple tubes containing LB medium and Ampicillin at different concentrations ranging from 0 to 3 mg/mL were inoculated with bacteria transformed with the shuttle vectors BBa_K802003 or BBa_K802004. The cultures were run in triplicate per Ampicillin concentration for each vector. As a negative control an Ampicillin sensitive strain was used to inoculate a solution of LB medium at the usual selective concentration of 100 µg/mL. The results are shown below :

BK37 stands for the NM522 strain transformed with BBa_K802003 (pBKL35) and BK38 stands for the NM522 strain transformed with BBa_K802004 (pBKH36)



To sum up, there is no significant difference concerning the Ampicillin concentration tolerance between the two strains, therefore between the two shuttle vectors as far as E. coli strains are concerned. At 2.4 mg/mL there is no bacterial growth for either strain.




B. subtilis tests

The shuttle vector was transformed into Bacillus subtilis 168 strain in order to be tested.

A) Agar plates
Saturated cultures containing the shuttle vectors were diluted 100 and 10,000 times. A volume of 5 µL of each solution containing the strain with BBa_K802003 part or with BBa_K802004 part was spotted on the plate.









35 stands for B. subtilis 168 strain transformed with BBa_K802003 (left side of each plate) and 36 stands for B. subtilis 168 strain transformed with BBa_K802004 (right side of each plate)







As it can be seen on the picture, B. subtilis transformed with BBa_K802004 grew perfectly well even for the culture diluted 10,000 times(the corresponding inoculum is indicated by the number 4 written on the plates on the picture). In contrast, B. subtilis transformed with BBa_K802003 shows antibiotic sensitivty for the most diluted cultures (10,000 x) at the four tested Erythromycin concentrations.












B) Liquid cultures

Multiple tubes containing LB medium and Erythromycin at various concentrations ranging from 0 to 1.5 mg/mL were inoculated with bacteria containing the shuttle vectors BBa_K802003 or BBa_K802004 and incubated 20 hours at 37°C. OD600 of the cultures was measured and the value was converted in cfu/mL[1]. The results are shown below :

BK49 stands for B. subtilis 168 strain transformed with BBa_K802003 (pBKL35) and BK50 stands for B. subtilis 168 strain transformed with BBa_K802004 (pBKH36)


Between 0 and 1 mg/mL there is no significant difference between the two strains. However, above 1.1 mg/mL there is significant bacterial growth for BK50 strain in contrast to BK49 strain. As a result, the shuttle vector BBa_K802004 gives a higher resistance to Erythromycin than BBa_K802003.



Sequencing of the modified regions

The two modified regions of the shuttle vector were verified by sequencing. The primers were designed using the sequences from the original plasmids that were used to construct the shuttle vector pHT315. The sequencing confirmed that the site SpeI was eliminated. However, there is still yet to confirm the iGEM polylinker, even though the gel electrophoresis confirmed the existence of all 4 of the iGEM sites.

Usage and Biology

It can be used to transform E. coli and B. subtilis strains. However, it is highly recommended to amplify the plasmid before transforming a B. subtilis strain because the transformation yield is low compared to E. coli.

Functional Parameters

The tests showed that in E. coli NM522 strain, there is bacterial growth in LB medium having an Ampicillin concentration up to 1.2 mg/mL. Concerning B. subtilis 168 strain, the bacteria transformed with this plasmid could be selected with Erythromycin concentrations as high as 1.2 mg/mL.

References

[1] http://bionumbers.hms.harvard.edu//bionumber.aspx?id=105453&ver=1


[edit]
Categories
Parameters
None