Difference between revisions of "Part:BBa K1602006"
(→Results) |
|||
| Line 68: | Line 68: | ||
<html> | <html> | ||
| − | The expression of cadA has been visualized via | + | The expression of cadA has been visualized via SDS-PAGE. The cells were induced utilizing IPTG for "" minutes/hours at "" degrees celsius. Afterwards the cells were lysated via ultrasonic cell disruption. |
<table> | <table> | ||
<colgroup width=50%> | <colgroup width=50%> | ||
| Line 93: | Line 93: | ||
</body> | </body> | ||
| − | </html> | + | </html> |
===<h2>Sequence and Features</h2>=== | ===<h2>Sequence and Features</h2>=== | ||
<partinfo>BBA_K1602006 SequenceAndFeatures</partinfo> | <partinfo>BBA_K1602006 SequenceAndFeatures</partinfo> | ||
Revision as of 22:19, 17 September 2015
Inducible itaconic acid producing construct (only cadA)
Itaconic acid is an organic, dicarboxylic acid that is biotechnologically synthesized most commonly in Aspergillus terreus. It is derived from citric acid via 2 intermediates and a final decarboxylation.To enable this pathway in Escherichia coli it is necessary to introduce 1 genes. This gene is taken from the genome Apergillus terreus. It is coding for a cis-aconitate decarboxylase (cadA). An Enzyme that catalyzes the following chemical reaction:
Figure 1 Reaction scheme of the itaconic acid producing operon (only cadA). The substrate for the reaction is cis-aconitate. Cis-aconitate is metabolized to itaconic acid in 1 step by decarboxylation.
Usage
This part is a composite of one coding gene, provided with a strong RBS (BBa_B0034) and under control of a T7 Promoter (BBa_I719005). Optimization of this operon may be possible through introduction of 2 more genes. Namely gltA (BBa_K1602001) and acnA (BBa_K1602002).
|
|
| Figure 2 Genetic map of the itaconic acid producing operon (only cadA) with T7 promoter. This brick enables E.Coli BL21 cells to synthesize itaconic acid in presence of the inductor IPTG. |
Results
The expression of cadA has been visualized via SDS-PAGE. The cells were induced utilizing IPTG for "" minutes/hours at "" degrees celsius. Afterwards the cells were lysated via ultrasonic cell disruption.
 |
|
|
Figure 3 Scan of the PAGE containing from left to right a marker (M; Protein Marker III AppliChem), the positive sample (1) and a negative control (2). The picture was cropped and edited for clarification purposes.
|
Figure 4 Plot of the gel lanes based on contrast analyses - created with ImageJ
|