Part:BBa_K3724010
Riboflavin biosynthesis protein RibF
The riboflavin biosynthesis protein, RibF, in Shewanella oneidensis MR-1 catalyzes the phosphorylation of riboflavin to flavin mononucleotide (FMN) then adenylation of FMN to FAD.
Usage and Biology
Shewanella oneidensis MR-1 are gram-negative bacteria at the center of studies of microbial reduction due to their ability to transfer electrons extracellularly to reduce materials such as graphene oxide (GO) [1]. Such characteristics have made S. oneidensis MR-1 an organism of interest in microbial fuel cells for bioelectricity generation and potential applications in bioremediation [2]. Two extracellular electron transfer pathways have been identified in the reduction of GO by Shewanella oneidensis MR-1. These are indirect electron transfer, mediated by secreted electron shuttles, and direct extracellular electron transfer (DET) which involves direct contact with the extracellular material [3]. It has been proposed that flavins may act as electron shuttles in the reduction of extracellular material by S. oneidensis MR-1 [4]. These flavins can exit the cytoplasm as flavin adenine dinucleotide (FAD) where they are then converted to riboflavin in the periplasm or in the extracellular space. ribf codes for the riboflavin biosynthesis protein which catalyzes the phosphorylation of riboflavin to flavin mononucleotide (FMN) then adenylation of FMN to FAD [5]. This FAD can then be transported into the periplasm by inner membrane flavin transporters. From the periplasm, FAD is converted to FMN where it is shuttled out of the cell then converted to riboflavin. Riboflavin has been seen to be the dominant flavin involved in reduction of extracellular material where it acts as a reducing electron shuttle eventually transferring its electrons to the terminal electron acceptor. Riboflavin has also been shown to be a key component in the transfer of electrons from biofilm in contact with electrodes as the terminal electron acceptor [6]. It was thought that increasing expression of ribf would increase the conversion of riboflavin to FAD and would therefore increase the amount of FAD shuttled into the periplasm to be reconverted to riboflavin for a faster rate of reduction.
We therefore synthesized the ribf gene from the S. oneidensis MR-1 genome and inserted it into the kanamycin resistant vector pcD8 under the control of an IPTG-inducible promoter (Keitz lab, University of Texas Austin) [7].
Results
Optical density measurements (O.D.600)
Previous studies have shown that the magnitude of reduction of graphene oxide can be measured using optical density measurements at a wavelength of 600 nm. It has also been shown that the presence of graphene oxide has no significant effect on the growth rate of S. oneidensis MR-1 [8]. So, we utilized this technique to measure and compare the magnitude of reduction with our different transformed strains and the wildtype.
Expression of our genes in our IPTG-inducible vector, pcD8, was initially induced with 1.5mM IPTG. Immediately following induction, reduction of graphene oxide was carried out under constant shaking at 200 rpm, and the O.D.600 was measured every hour for 48 hours for TSB only, graphene oxide only, graphene oxide and TSB only, and graphene oxide and TSB each with ribf and the wildtype. Here, the TSB only , graphene oxide only, and graphene oxide and TSB only are our negative controls, and wild type MR-1 is the positive control to which all our transformed strains are compared. The O.D.600 measurements obtained from these experiments reflect both bacterial absorbance as well as reduced graphene oxide absorbance. So, the absolute O.D.600 due to reduced graphene oxide is obtained by correcting for O.D.600 bacteria and TSB only.
Figure 1 shows the microbial reduction of graphene oxide with the transformed strain, ribf. It represents the combined O.D.600 measurements for the reduced graphene oxide absorbance and bacterial absorbance. The figure shows that transformation of S. oneidensis MR-1 with ribf still allows for reduction following a lag from the initiation of reduction as compared to the wildtype and pcD8. However, at its steepest point, the O.D.600 curve, which signifies the increase in reduction, is comparable to that of the wildtype and the empty vector, pcD8.
The bacterial growth over the 48-hour period was measured by means of O.D.600 to determine the impact of ribf expression on bacterial growth. Figure 2 shows that bacteria expressing the ribf gene (deep purple) had a delay in growth for the first 20 hours as compared to the wildtype (dark gray) and the other expressed genes. Beyond that point, the bacterial growth evens out to be about the same as the wildtype and pcD8.
To get the absolute O.D.600, representative of the reduced graphene oxide content in the microbial reduction, the measured O.D.600 was corrected for the O.D.600 for bacterial growth in TSB only. Figure 3 shows that after correction for bacterial growth ribf , at the steepest point on its curve, had a comparable rate of reduction with the wildtype and pcD8. The lag in reduction with ribf may be due to its initial delay in growth when compared to the other strains.
Since ribf showed slower growth than wild-type MR-1 (Figure 2), we hypothesized that the induced gene may have been slightly toxic to the cells. We then observed the growth curve when the concentration of IPTG was decreased to 1.0mM to reduce the amount of ribf expression.
Figure 4 shows that with 1.0mM IPTG induction, microbial reduction of graphene oxide with the transformed strain ribf still had the initial lag in reduction but after the 5 hour mark, its reduction curve was comparable to wild-type MR-1 and the empty vector, pcD8. From the figure the slope of the reduction curve of ribf after 5 hours looks as steep as the slope for the curve of the wildtype without corrections for bacterial growth.
Figure 5 shows an increase in the delay in the growth for ribf for induction with 1.0mM IPTG as compared with 1.5mM IPTG (Figure 2). However, with 1.0mM IPTG the exponential growth following the delay is faster than that of 1.5mM IPTG induction.
Figure 6 shows that with the correction for bacterial growth, microbial reduction with ribf with 1.0mM IPTG induction at the steepest region of its curve had a greater rate of reduction as compared to the wildtype and pcD8.
We carried out an induction time of 5 hours prior to reduction to allow ribf to already have the its enhanced electron transport pathway fully active before we began the reduction reaction. This was carried out with either 1.5mM or 0.75mM of IPTG under the same conditions of shaking at 200 rpm.
From Figure 7, the microbial reduction of graphene oxide with the transformed strain ribf shows a comparable rate of reduction to that of the wildtype after its initial delay without any corrections to the O.D.600 measurements for bacterial growth. It also shows a comparable rate of reduction to that of pcD8.
The bacterial growth measured by O.D.600 in Figure 8 shows that bacteria expressing the ribf gene (deep purple) still had the initial delay with the 5hr induction, however it is greater in magnitude as compared to the delay in the 1.5mM IPTG and 1.0mM IPTG 0hr induction (Figure 2,5). It also has a greater exponential increase in growth and exceeds the growth of the wildtype and pcD8 after 24 hours.
After corrections for bacterial growth, Figure 9 shows that ribf has a faster rate of microbial reduction at the steepest region of its curve as compared to the curves for wildtype and pcD8.
Figure 10 shows that the microbial reduction of graphene oxide with the transformed strain ribf at 0.75mM IPTG 5 hr induction has comparable rate of reduction with that of the wildtype and pcD8 following its initial delay in reduction without any corrections to the O.D.600 measurements for bacterial growth.
Figure 11, shows that the delay in growth in ribf (deep purple) with 0.75mM IPTG is decreased from that seen with 1.5mM IPTG for 5hr induction (Figure 8). However, even with the concentration of IPTG reduced to half from 1.5mM, the growth curve of ribf still lags behind the wildtype and pcD8.
Figure 12, shows that the microbial reduction of graphene oxide with the transformed strain ribf at 0.75mM IPTG 5 hr induction has a comparable rate of reduction with that of the wildtype and pcD8 following its initial delay in reduction after adjusting for the bacterial growth.
The growth curves of ribf show an initial delay with each of the IPTG conditions (Figure 2,5,8,11). However, with lower concentrations of IPTG, there was a shorter delay in bacterial growth which may indicate that over-expression of ribf may have some toxic effect on S. oneidensis MR-1.
The slopes at the steepest point on the curves were obtained for each induction condition to give the maximum reduction rate measured during the reduction period, and this was compared to that of wild-type MR-1.
The results show that after a 0hr induction with 1.5mM IPTG as well as 1.0mM IPTG, ribf has a faster rate of reduction as compared to wild-type MR-1 (Figure 3,6). Figure 13 shows that the maximum rate obtained for ribf at these conditions were 10.184 hr-1 and 9.956 hr-1, respectively, whereas the wildtype had a rate of 8.936 hr-1. It also shows that after 5hr induction with 1.5mM IPTG, the rate of reduction for ribf (8.356 hr-1) was greater than that of wildtype (7.732 hr-1) and comparable to that of wild type at 5hr induction with 1.0mM IPTG.
The negative controls (TSB only, GO only, and GO and TSB only) show an insignificant change in O.D.600 over time indicating that the bacteria are responsible for the increase in O.D.600 which is the measure of reduction of graphene oxide in these experiments.
Raman spectroscopy
Raman spectroscopy was carried out to investigate the amount of carbon-carbon single bonds of the reduced graphene oxide produced by ribf after the 48 hour period. We primarily relied on the D/G ratio, which is the intensity of the D peak divided by the intensity of the G peak. The D peak is associated with double-bonded carbon, and the G peak is associated with single-bonded carbon.
We used chemically reduced GO as our positive control as chemical reduction with ascorbic acid results in a much greater degree of reduction than seen in microbial reduction. We also had two negative controls: GO only and GO and TSB media only.
After reduction, we compared the D/G ratios to determine how well our transformed strain had done in reducing the number of Sp2 carbons.
As Figure 14 shows, the chemically reduced GO was by far the most reduced, with an average D/G ratio of around 1.2. The microbial reduction with ribf resulted in a D/G ratio of 0.97 which is close to the D/G ratio of wildtype. This demonstrates that our part worked as intended and was able to reduce the GO to expected levels of reduction during the reduction period.
Conclusion
We were able to successfully transform the riboflavin biosynthesis protein RibF into S. oneidensis MR-1. This transformed strain showed greater maximum reduction rates than wildtype with controlled expression and also reduced the graphene oxide to levels expected with microbial reduction for S. oneidensis MR-1. This indicates that expression of ribf in S. oneidensis MR-1 ,operating at its maximum rate of reduction, may decrease the time it takes for graphene oxide to be reduced to expected reduction levels for microbial reduction. Sequence and Features
- 10COMPATIBLE WITH RFC[10]
- 12COMPATIBLE WITH RFC[12]
- 21COMPATIBLE WITH RFC[21]
- 23COMPATIBLE WITH RFC[23]
- 25COMPATIBLE WITH RFC[25]
- 1000INCOMPATIBLE WITH RFC[1000]Illegal BsaI site found at 7
Illegal BsaI.rc site found at 955
References
[1] Wang, G.; Qian, F.; Saltikov, C. W.; Jiao, Y.; Li, Y. Microbial Reduction of Graphene Oxide by Shewanella. Nano Research 2011, 4, 563–570.
[2] Schwalb, C.; Chapman, S. K.; Reid, G. A. The Tetraheme Cytochrome Cyma Is Required for Anaerobic Respiration with Dimethyl Sulfoxide and Nitrite in Shewanella Oneidensis. Biochemistry 2003, 42, 9491–9497.
[3] Lin, T.; Ding, W.; Sun, L.; Wang, L.; Liu, C.-G.; Song, H. Engineered Shewanella Oneidensis-Reduced Graphene Oxide Biohybrid with Enhanced Biosynthesis and Transport of Flavins Enabled a Highest Bioelectricity Output in Microbial Fuel Cells.
[4] Kouzuma, A.; Kasai, T.; Hirose, A.; Watanabe, K. Catabolic and Regulatory Systems in Shewanella Oneidensis MR-1 Involved in Electricity Generation in Microbial Fuel Cells. Frontiers in Microbiology 2015, 6.
[5] UniProt Consortium European Bioinformatics Institute Protein Information Resource SIB Swiss Institute of Bioinformatics. Riboflavin biosynthesis protein.
[6] Marsili, E.; Baron, D. B.; Shikhare, I. D.; Coursolle, D.; Gralnick, J. A.; Bond, D. R. Shewanella Secretes Flavins That Mediate Extracellular Electron Transfer. Proceedings of the National Academy of Sciences 2008, 105, 3968–3973.
[7] Dundas, C. M.; Walker, D. J. F.; Keitz, B. K. Tuning Extracellular Electron Transfer by Shewanella Oneidensis Using Transcriptional Logic Gates. ACS Synthetic Biology 2020, 9, 2301–2315.
[8] Lehner, B. A.; Janssen, V. A.; Spiesz, E. M.; Benz, D.; Brouns, S. J.; Meyer, A. S.; van der Zant, H. S. Creation of Conductive Graphene Materials by Bacterial Reduction Using Shewanella Oneidensis. ChemistryOpen 2019, 8, 888–895.
| None |