Difference between revisions of "Part:BBa K389015:Experience"

Revision as of 13:02, 25 October 2010

This experience page is provided so that any user may enter their experience using this part.
Please enter how you used this part and how it worked out.

Applications of BBa_K389015

Response time

The system needs at least one hour to show a measurable reaction to an induction with acetosyringone. In the following illustration the reaction of the system to induction with 200 µM acetosyringone in the exponential growth phase is shown. For a good separation of the induced system from the uninduced system at least two hours are needed.

Error creating thumbnail: Invalid thumbnail parameters

Cultivation of BBa_K389015 in Escherichia coli DB3.1. Induction with 200 µM acetosyringone during the exponential growth phase.

Data Analysis

Because the luciferase accumulation is very different in different cultivations, the uninduced negative control was used as internal standard. To show the behaviour of the VirA/G signaling system when induced, the ratio ɸ_I between induced (i) and uninduced (u) relative luminescence unit (RLU) per OD₆₀₀ is calculated:

(1)

As seen above, at least one hour is needed to separate the induced luminescence signal from the uninduced, so ɸ_I > 1. Within a cultivation ɸ_I is rising during the first hours and is decreasing after it reached a maximum at OD₆₀₀ ~ 1. This is shown in the following figure:

To measure the ratio of increasing promoteractivity by inducing the system ɸ_I samples for analyzation should be taken at OD₆₀₀ ~ 1.

Protocols

1. bla

User Reviews

UNIQe6729f1ccdd9aef0-partinfo-00000001-QINU UNIQe6729f1ccdd9aef0-partinfo-00000002-QINU

@@ Line 19: / Line 19: @@
-As seen above, at least one hour is needed to separate the induced luminescence signal from the uninduced, so ɸ<sub>I</sub> > 1.
+As seen above, at least one hour is needed to separate the induced luminescence signal from the uninduced, so ɸ<sub>I</sub> > 1. Within a cultivation ɸ<sub>I</sub> is rising during the first hours and is decreasing after it reached a maximum at OD<sub>600</sub> ~ 1. This is shown in the following figure:
+To measure the ratio of increasing promoteractivity by inducing the system ɸ<sub>I</sub> samples for analyzation should be taken at OD<sub>600</sub> ~ 1.
 ====Protocols====