Difference between revisions of "Part:BBa K3930003"

Revision as of 10:13, 16 October 2021

α-ionone induction system and expression in Saccharomyces cerevisiae (pViolette) Sequence and Features

Introduction

The pVIOLETTE part (BBa_K3930003) enables the production of α-ionone from lycopene and is composed of:

- the up (BBa_K3930021) and down (BBa_K3930022) integration sites in the XII-4 locus of the S. cerevisiae genome (based on the plasmid pCfB3040 from Easyclone Marker free kit (Jessop-Fabre et al.,2016))

- the LcyE-ofCCD1 fusion (BBa_K3930024) codes for a carotenoid cleavage dioxygenase fused to a lycopene cyclase, which allows the production of α-ionone. The sequences were codon optimized for expression into S. cerevisiae

- the galactose inducible promoter pGal1 (BBa_K3930023), driving the expression of LcyE-phCCD1

- the resistance marker NsrR (BBa_K3930025) to select yeast integrants

Construction

IDT and Twist Bioscience performed the DNA synthesis and delivered the part as gBlock. The construct was cloned with an In-Fusion Takara kit into the pCfB3040 plasmid and then transformed into E.coli Dh5α strain. Figure 1 shows the restriction map of the resulting clones. The expected restriction profile was obtained for clone 3.

Figure 1: pVIOLETTE assembly

pVIOLETTE restriction profile from clone 3 was checked by digestion visualised on EtBr stained agarose electrophoresis gel. A theoretical gel is presented on the right and the NEB 1 kb DNA ladder on the left (note that a different ladder is presented on the theoretical gel)

pVIOLETTE insert was then linearized with the F and R linearization primers pVIOLETTE. Then the amplicon was integrated into the genome of our LycoYeast strain with the Takara Yeast transformation protocol. Figure 2 shows the electrophoresis gel of colony PCR to verify integrants genotype. The expected size was obtained for clone 2.

Primer used to clone this part in the pCfB3040:

• pVIOLETTE_pCfB3040_Forward : 5' cgcccttattcgactctatag 3'
• pVIOLETTE_pCfB3040_Reverse : 5' cgtacctggatggtcatttc 3'

Figure 2: Integration of pVIOLETTE insert in LycoYeast

pVIOLETTE insert integration from clone 1 and 2 was checked by PCR visualised on EtBr stained agarose electrophoresis ge. A theoretical gel is presented on the right and the NEB 1 kb DNA ladder on the left (note that a different ladder is presented on the theoretical gel)

pVIOLETTE insert integration at locus XII-4 was successful. The integrant strain was named LycoYeast-pVIOLETTE and saved as glycerol stock.

Characterisation

Production of α-ionone

After verifying the correct integration of our insert by PCR, our engineered LycoYeast strains were placed on YPD plates containing the inducers with the aim to detect color changes due to the conversion of lycopenes (red) to carotenes (orange).

Figure 3 shows the colors of the colonies with or without the inducer, the galactose. The LycoYeast-pVIOLETTE strain plated on a YPGal Petri dish shows a yellow coloration, indicating the degradation of lycopene into ε-carotene.

Figure 3: Color change in the modified LycoYeast strains

The mutants seem to change from red (lycopene) to orange (carotene) when plated with the galactose activator, which was the expected result

The carotenoids contained in the cells were extracted using the method described by López et al. (2020). Yeast cells were lysed in acetone using glass beads and the supernatant obtained after this lysis was analyzed by RP-HPLC using a C18 column.In the LycoYeast-pVIOLETTE strains, Figure 4 shows that lycopene is converted into a new product with a higher retention time upon induction. Considering the yellow color of pVIOLETTE strains, as well as the in-line following α-ionone production results, this new peak most likely corresponds to ε-carotene, the expected precursor.

Figure 4: Carotenoid analysis of the engineered strain LycoYeast-pVIOLETTE

tr= retention time; 3 peaks are observed in a non-modified and a modified but not induced LycoYeast while 4 peaks are present in a LycoYeast-pVIOLETTE strain.

The α-ionone is very volatile. A common strategy to avoid losing these molecules during the culture is to grow the engineered microorganisms in a culture medium supplemented with an organic phase to trap the molecules of interest.The most common organic solvent used is dodecane for ionones (Chen et al. 2019; López et al. 2020).Figure 5 shows the GC-MS spectrum for the LycoYeast-VIOLETTE strain. A peak can be observed at the same retention time as the α-ionone standard for the induced LycoYeast-VIOLETTE strain. The mass spectra associated with this peak matched with the one obtained with the analytical standard. The α-ionone attribution was further confirmed by the NIST mass spectral library (National Institute of Standards and Technology).The production of alpha-ionone, the main molecule of the violet odour, was successfully achieved with this construction.

Figure 5: GC-MS analysis of the dodecane layer of the LycoYeast-pVIOLETTE

α-ionone is produced in vivo by our strain when it is induced by galactose. On the right are presented the mass spectra that correspond between the standard and the observed peak.

Conclusion and Perspectives

These results show that pVIOLETTE has the ability to degrade lycopene into ε-carotene and futher transform it into the α-ionone. The quantification of α-ionone production remains to be determined under the optimal conditions for the production of the molecule of interest.

The α-ionone belongs to the terpene family and may have other uses besides perfumery, notably in medicine. We sincerely thank the future teams that will use this construction and encourage them to contact us for further details.

References

1. Chen X, Shukal S, Zhang C. 2019. Integrating Enzyme and Metabolic Engineering Tools for Enhanced α-Ionone Production. J Agric Food Chem. 67(49):13451–13459. doi:10.1021/acs.jafc.9b00860.
2. Jessop-Fabre MM, Jakočiūnas T, Stovicek V, Dai Z, Jensen MK, Keasling JD, Borodina I. 2016. EasyClone-MarkerFree: A vector toolkit for marker-less integration of genes into Saccharomyces cerevisiae via CRISPR-Cas9. Biotechnol J. 11(8):1110–1117. doi:10.1002/biot.201600147.
3. López J, Bustos D, Camilo C, Arenas N, Saa PA, Agosin E. 2020. Engineering Saccharomyces cerevisiae for the Overproduction of β-Ionone and Its Precursor β-Carotene. Front Bioeng Biotechnol. 8:578793. doi:10.3389/fbioe.2020.578793.