Difference between revisions of "Part:BBa K3365014"

Revision as of 08:11, 27 October 2020

pBAD/araC upstream of RFP with inhibition unit containing target

To facilitate measurements, we use the RFP as a reporter protein, which can be exchange to other reporters according to the users’ needs. The RFP gene sequence (BBa_K3365052) is located directly downstream of BBa_K3365006 (Target sequence downstream of pBAD/araC) followed by BBa_B0015 (rrnBT1-T7TE). The transcription of the RFP gene is under the control of the inducible pBAD/araC promoter designed to carry PAM and target sequence downstream of pBAD. In our part, the “target” is the target sequence for PDCD1 CRISPR gene editing in one clinical trial, which can be identified and bound by the complex of dCas9 and corresponding sgRNA.

Usage and Biology

This part is used to expression of RFP protein regulated by the signal of arabinose and the on-target or not of dCas9. The pBAD is regulated by the AraC protein, which is both a positive and a negative regulator. The binding of dCas9 to any position within the region between the promotor and RBS might prevent transcription. Therefore, the uninduced transcriptional level of RFP is very low. In the presence of arabinose, transcription from the pBAD promoter is turned on and there will be a relatively strong fluorescence expression. In the presence of both arabinose and the complex of dCas9 and sgRNA, the complex might bind to the target sequence and the transcription is partially inhibited because of the block of RNAP. So, a relatively weak fluorescence expression of bacteria indicates a dCas9 with higher on-target rate that effectively inhibits the expression of reporter gene.

Results

The inducible pBAD/araC promoter (BBa_K3365013) is amplified with the primer F1/R1 to add restriction cutting sites, target sequence and part of the RBS sequence (BBa_K3365002). The RFP with double terminator is amplified with the primer F2/R2 to add restriction cutting sites and part of the RBS sequence (BBa_K3365002). The above PCR products are ligated through overlap PCR with the primer F1/R2 to get the fragment with suitable restriction sites and the product can be ligated into its backbone pUC57 by enzymic digestion and connection. The eletrophoretic profile of the overlap PCR (F1/R2) and colony PCR (M13 fwd/ M13 rev) product and the sequencing result reveal the successful construction of the fragment and the plasmid, named pIn-RTr.

F1: 5’-CGAGCTCTTATGACAACTTGACGGCTACATCATTCAC-3’ R1: 5’-TTCTTAAAGGCAGTTGTGTGACACGGAAGCGGATGGAGAAACAGTAGAGAGTTGCG-3’ F2: 5’-TTCCGTGTCACACAACTGCCTTTAAGAAGGAGATATACATATGGCGAGTAGCGAAGACG-3’ R2: 5’-GGAATTCCCGCCCTAGGTATAAACGCAGAAAG-3’ M13 fwd: 5’-GTAAAACGACGGCCAGT-3’ M13 rev: 5’-GTCATAGCTGTTTCCTG-3’

Sequence and Features