Difference between revisions of "Part:BBa K3282005"

Revision as of 17:31, 17 October 2019

pbrD and pbrT under T7 promoter

The part consists of T7 promoter (BBa_I719005), two Anderson RBS (Part:BBa_J61109), separating two coding regions of lead binding protein (BBa_K3282002) and lead transport protein (BBa_K3282001), followed by a TE terminator (Part:BBa_B0012).

The pbrD gene encodes a Pb(II)-binding protein which is essential for functional lead sequestration whereas the expression of pbrT leads to uptake of lead into the cytoplasm to reduce interaction of free Pb(II) with side chains of membrane and periplasmic proteins, which would cause extensive cellular damage [1].

Experiment

This part was ligated into pUC19 and transformed into E. coli BL21(DE3). The expression of pbrD and pbrT was demonstrated by performing SDS-PAGE analysis. The cells were cultured in enriched media (containing peptone, yeast extract, phosphates, chlorides and sulphates) at 37 °C. The cells were grown overnight followed by cell harvesting to normalize the OD values to 2. After normalization, the cells were resuspended in fresh enriched medium containing 10 µM, 50 µM and 200 µM of Pb(NO3)2. As a negative control, the experiment was also performed with the non engineered E. coli BL21(DE3) in growth medium containing 50 µM Pb(NO3)2. Samples were collected every hour for OD measurement. For investigating the lead accumulation by engineered bacteria, samples were collected at 0 hour, 2.5 hour and 5 hour after the addition of Pb(NO3)2.

Results

The SDS-PAGE analysis result can be seen in Figure 1. The pbrD is a 26.7 kDa and pbrT 68.3 kDa protein. Therefore the bands were expected just above the 25kDa band and just below 70kDa band for pbrD and pbrT respectively. The gel shows that the engineered bacteria as well as the control have bands with the expected molecular weight. Thus, we cannot confirm that the bands corresponds to the desired proteins. It is possible that there are other proteins expressed in E. coli of the same molecular weight, masking the expression of pbrD and pbrT.

Figure 1: Bioaccumulation of Lead. Samples were harvested at different time points, and the total cellular proteins were analyzed by sodium dodecyl sulfate-polyacrylamide gel electrophoresis. Image with protein bands of BL21(DE3) after induction with IPTG, showing pbrD at 26.7 kDa and pbrT at 68.3 kDa. The control shown is non-engineered BL21(DE3) without pbrD and pbrT.

Figure 2: Comparison of lead uptake by engineered BL21(DE3) with non-engineered control of BL21(DE3).

Figure 3: Comparison of growth rate of engineered BL21(DE3) with non-engineered control of BL21(DE3).

For the engineered cells, the initial lead concentration added was 10.63 mg/L and the final calculated concentration was 0.76 mg/L, showcasing a 93.92% decrease in lead concentration. The control showed a 93.63 % decrease in lead concentration with the final lead concentration being 0.59 mg/L. This rapid decrease can be attributed to the use of borosilicate Erlenmayer flasks and it was found that borosilicate glass can adsorb lead ions [2]. However, the study also mentions that adsorption of lead by borosilicate glass is time dependent and adsorption was found to be only 17.2% over a period of 20 hours. This concludes that not all the lead adsorption was by borosilicate glass but also by the bacterial strains. The difference in the lead concentration between the engineered Bl21(DE3) containing lead uptake and transport proteins, and the non-engineered BL21(DE3) without the proteins is not that significant, as can be seen in Figure 2.

Future Improvements

Since there was no visible protein expression at the expected position, one could try to add a histidine tag, making purification of protein possible and one would be able to assess the protein expression. Another solution would be to use a stronger promoter, which would give a higher expression of protein, and might be visible on the SDS-PAGE. Another improvement could be to make sure the protein is not stuck in the wells of the gel. Further, fluorescent protein reporters such as GFP and RFP can be used for more convenient protein detection and stronger output signals as shown by Xiaoqiang, J et al [3].

References

1. Borremans, B., Hobman, J. L., Provoost, A., Brown, N. L., & van Der Lelie, D. (2001). Cloning and functional analysis of the pbr lead resistance determinant of Ralstonia metallidurans CH34. Journal of bacteriology, 183(19), 5651–5658. doi:10.1128/JB.183.19.5651-5658.2001

2. Kim, N. D., & Hill, S. J. (1993). Sorption of lead and thallium on borosilicate glass and polypropylene: Implications for analytical chemistry and soil science. Environ Technol, 14(11), 1015-1026. doi:10.1080/09593339309385378

3. Xiaoqiang Jia, Tingting Zhao, Yilin Liu, Rongrong Bu, Kang Wu, Gene circuit engineering to improve the performance of a whole-cell lead biosensor, FEMS Microbiology Letters, Volume 365, Issue 16, August 2018, fny157, https://doi.org/10.1093/femsle/fny157

Sequence and Features