Difference between revisions of "Part:BBa K3020000:Experience"
WANGWENJIA (Talk | contribs) (→date analysis) |
WANGWENJIA (Talk | contribs) (→User Reviews) |
||
Line 22: | Line 22: | ||
<center><b>induction factor Fi=SFUx/SFU<small>0</small></b></center><div> | <center><b>induction factor Fi=SFUx/SFU<small>0</small></b></center><div> | ||
Where SFUx is a sample treated with a toxic compound and SFU0 is a control sample at the same time point. In this experiment, the inducing factor Fi value was used to evaluate the ability of the compound to damage the reagent. It can be seen from the literature that when the induction time is 2 h, the Fi factor value of any compound at any concentration reaches 2 or higher. This compound was identified as a DNA damaging agent. | Where SFUx is a sample treated with a toxic compound and SFU0 is a control sample at the same time point. In this experiment, the inducing factor Fi value was used to evaluate the ability of the compound to damage the reagent. It can be seen from the literature that when the induction time is 2 h, the Fi factor value of any compound at any concentration reaches 2 or higher. This compound was identified as a DNA damaging agent. | ||
+ | |||
+ | ====results==== |
Revision as of 08:45, 10 September 2019
This experience page is provided so that any user may enter their experience using this part.
Please enter
how you used this part and how it worked out.
Applications of BBa_K3020000
User Reviews
Typical DNA damage agents include nalidixic acid (NA) (Sigma), formaldehyde (formaldehyde, CH2O) (Sigma) and hydrogen peroxide(H2O2).The following non-DNA damage reagent was used as a negative control:kanamycin sulfate,KAN)(Amresco),acetone,phenol. The reagent concentration and gradient were calculated and added to the 40 ml bacterial solution (LB) system according to the following induction volume.
The BL21 strain introduced with Part:BBa_K3020000 was cultured overnight in LB medium (AMP resistance) at 37°C, and inoculated into fresh LB liquid medium (AMP resistance) at 1:50 inoculation, and shake cultured at 37 ° C for 3 hours. The OD600 is 0.2-0.4. Add DNA damaging agents and non-injury agents with different concentration gradients. The concentration and dosage are shown in the above figure. Induction at 37°C 130 r / min for 2-3 h. Standard error was taken three times for each set of experiments.
date analysis
OD600 represents the absorbance or optical density of a sample measured at a wavelength of 600 nm, which is a common method for estimating the concentration of bacteria or other cells in a liquid. The measured concentration can indicate the stage of culturing the cell population, ie whether it is in a lag phase, an exponential phase or a stationary phase.Where SFUx is a sample treated with a toxic compound and SFU0 is a control sample at the same time point. In this experiment, the inducing factor Fi value was used to evaluate the ability of the compound to damage the reagent. It can be seen from the literature that when the induction time is 2 h, the Fi factor value of any compound at any concentration reaches 2 or higher. This compound was identified as a DNA damaging agent.
====results====