Difference between revisions of "Part:BBa K2213001"

Revision as of 19:28, 1 November 2017

Tet_EutMN

Ethanolamine Utilisation (Eut) bacterial micro-compartment (BMC) proteins EutM and EutN from E.coli , placed under the inducible Tetracycline promoter. Also contains RBS, terminators and all tetp components – thus this part alone can be used to synthesise EutM and EutN at varying concentrations, relevant to the experimental task. EutM is tagged with GFP and His6. EutN is tagged with FLAG. See Figure 1.

Tetracycline Promoter

The tetracycline expression system is based on two regulatory elements, the tetracycline repressor protein (TetR) and the tetracycline operator sequence (tetO); both derived form the tetracycline-resistance operon of the E.coli Tn10 transposon. In our part, tetracycline (Tc) can bind rTetR, increasing its affinity for DNA binding. Thus upon Tc addition, rTetR can bind tetO, permitting transcription of any gene under control of the tet promoter. This is illustrated in Figure 2.

Several iGEM teams have previously carried out characterisation and worked with the Tet promoter system. For your interest and research, we recommend looking at the HQ submitted part BBa_R0040 (https://parts.igem.org/Part:BBa_R0040) as a starting point.

EutM and EutN

The Ethanolamine Utilisation (Eut) bacterial micro-compartment (BMC) proteins EutM and EutN from E.coli are clustered together here, as they are found in nature.

Usage and Biology

Although it is possible to use this part for EutM and N expression without further assembly, we do not recommend doing this if the ultimate goal is to produce fully functional Eut BMCs. When forced to produce BMCs, E. coli are placed under a large amount of strain and begin to experience slowed and abnormal growth (see characterisation data below). Therefore, we suggest using a low copy number plasmid eg. pSB4A5 (https://parts.igem.org/Part:pSB4A5), as we have used in our project. By using a low copy number plasmid, cellular stress is minimised, but the experimenter still has the ability to induce BMC formation.

Characterisation

Understanding growth defects upon Eut protein expression
Following the succesful transformation of Eut constructs into E. coli Manchester iGEM 2017 noticed that cultures grew at a slower rate after Eut subunit protein expression had been induced. This lead to the investigation of how each of Eut construct https://parts.igem.org/Part:BBa_K2213000 , https://parts.igem.org/Part:BBa_K2213001 and https://parts.igem.org/Part:BBa_K2213002 affected growth rate after it had been induced.

Manchester iGEM 2017 recorded optical density measurements at 600nM for EutS, EutMN, EutSMN and EutLK. OD measurements were taken at 0 hours, 4 hours and at 20 hours (see figure 3). It was observed that between 4 and 20 hours, the OD of cultures containing the constructs EutMN, EutSMN and EutLK were reduced by 75.53%, 81.77% and 67.93% respectively. In contrast to this, the OD of the EutS culture continued to rise and had increased by 45.28% when the final reading was taken at 20 hours. This suggests that the production of microcompartment subunits EutM, EutN, EutL and EutK are toxic to the cell, however, the production of EutS may be less toxic. This may be due to less strain being put on the cell due to the expression of a single microcompartment subunit, rather than multiple subunits being expressed simultaneously. Overall this data indicates that the expression of complete microcompartments is likely to be toxic to the cell and should be highly regulated.


Figure 3. Average optical density at 600 nM of EutS, EutMN, EutSMN constructs induced and non-induced. Measurements were taken at 0 hours, 4 hours and 20 hours.


Measuring BMC subunit expression
Manchester iGEM 2017 measured GFP fluorescence to determine if the expression of EutM had been successful. They found a significant increase in fluorescence at both a 4 and 20-hour time point (p = 0.0016 and p = 0.0054 respectively), produced by cells containing the EutMN construct under inducing conditions. Similarly, there was also found to be s significant increase in fluorescence produced by cells containing the EutSMN construct at both the 4 and 20-hour time points (p = 0.002 and p = 0.0007 respectively). This confirmed that the TetR promoter was working as expected, controlling the induction of the EutMN construct (see figures 4 and 5.


Figure 4. Average OD corrected fluorescence (Ex. λ 470-15 / Em. 515 – 20 nM) measurements of EutS, EutSM, EutSMN and EutLK constructs, non-induced and induced taken after 4 hours. Error bars show the SEM.



Figure 5. Average OD corrected fluorescence (Ex. λ 470-15 / Em. 515 – 20 nM) measurements of EutS, EutSM, EutSMN and EutLK constructs, non-induced and induced taken after 20 hours. Error bars show the SEM.

Optimising conditions for EutM synthesis using 'Design of Experiments'
To find the optimal conditions of EutM microcompartment formation we used a tool called 'Design of Experiments' to vary a multitude of factors including:

• concentration of Tetracyclin inducer (induces EutMN synthesis)
• concentration of IPTG inducer (induces EutS synthesis)
• Harvest time (time after induction)
• Temperature
• Growth Medium (LB and TB)

We determined the concentration of EutM by measuring the GFP fluorescence of the solution and dividing it by the OD of the culture at that time. This gave us the average GFP fluorescence per cell which is proportional to the amount of EutM produced per cell. / from this 22 flask investigation we were able to make surface plots to visualise our findings:

Figure1: A surface plot of the interactions between the concentration of tetracycline inducer (x axis), Temperature after induction (y axis) and Average GFP fluorescence per cell (z axis). From this graph, it can be deduced that a lower temperature after induction and a higher tetracyclin concentration in the inducer increases the amount of EutM protein produced per cell.

Figure2: This graph is like figure1, except IPTG concentration in the inducer is being compared instead of Tet. IPTG induces the LacUV5 promoter which transcribes the EutS gene. By having a high IPTG concentration in the inducer, the concentration of EutM per cell increases. This implies that the presence of EutS is increasing the stability of the EutM protein. This may be due to the binding of EutSMN proteins to form partially formed microcompartments, potentially improving the stability of EutM protein.

Figure3: The interactions between the concentration of tetracycline inducer (x axis), Harvest time (y axis) and Average GFP fluorescence per cell (z axis). From this graph, it can be seen that a low harvest time and a high harvest time yields the highest EutM synthesis per cell.

Figure4: This graph is like figure3, except IPTG concentration in the inducer is being compared instead of Tetracycline concentration. IPTG induces the LacUV5 promoter which transcribes the EutS gene. At a lower harvest time, IPTG concentration in the inducer has little effect on the EutM concentration (z axis). However, at higher harvest times, IPTG concentration has a significant effect on EutM concentration. We believe that this relationship is caused by the binding of EutS, M and N proteins forming partially formed microcompartments and thus increasing the half-life of the EutM protein.

Sequence and Features