Difference between revisions of "Part:BBa K540001"

Line 42: Line 42:
 
To conclude, this work shows that this promoter can be used with efficiency in a cobalt sensitive system.
 
To conclude, this work shows that this promoter can be used with efficiency in a cobalt sensitive system.
  
 
+
<html>
Corroboring results of this characterisation can be seen on the main page of an other part characterisation, <a  href="https://parts.igem.org/Part:BBa_K540000"/>BBa_K540000</a>.  
+
Corroboring results of this characterisation can be seen on the main page of an other part characterisation,  
 
+
<a  href="https://parts.igem.org/Part:BBa_K540000"/>BBa_K540000</a>.  
 +
</html>
 
=== Safety ===
 
=== Safety ===
  

Revision as of 19:08, 21 September 2011

rcn, cobalt-sensitive promoter

Prcn is a promoter that is activated by cobalt. The RcnR repressor binds to the promoter by default. When enough cobalt molecules accumulate in the cell cytoplasm, the cobalt ions bind to this repressor and prevent its fixation on the rcn promoter.

Prcn is also activated by nickel, but we have not characterized this aspect.

Characterization

Kinetic Mesurement


Important : this characterization hasn't been done with this biobrick and an iGEM Gfp. It has been done with the wild type promoter. The part we provide contain the exact sequence of the promoter but a silent mutation to remove a PstI site. The GFP used here, is a stable GFP.

In order to determine wether rcn promoter is inducible by cobalt or not, a kinetic of the fluorescence (excitation 490nm, emission 510nm) of the two following strains has been done:
NM522/p157 where p157 is a plasmid containing a stable GFP under the control of rcn promoter.
NM522/p115 where p115 is the p157 corresponding control plasmid.

Both strain are cultivated with (25µM) or without cobalt. 1ml of bacteria is added to a mix of 100ml of M63G medium + 1ml of spectinomycin in a 250ml erlen. The erlens are put in a 37°C bath with a 270rpm agitation. Every hour, a 3mL and 1mL culture sampling are done for a fluorescence measurement and a OD(600nm) measurement respectively. Near an OD(600nm) of 1, samplings are done every half hour. The measurements are stopped when the OD reaches 1. A last sampling is done after an overnight growth.

The experiment has been performed in triplicate and the results shown below are the mean values obtained from the 3 operators.


INSA-ENS_RCN-GFP_FluoDo%3Dft.png
INSA-ENS_RCN-GFP_FluoDo%3DfDo.png

It is shown out from these two graphics that the strain NM522/p115 (carrying a control plasmid) doesn't have any fluorescent activity and does not respond at all to cobalt. Whereas the strain NM522/p157 (carrying a plasmid with GFP under the control of rcn promoter) responds well to cobalt. A fluorescent activity is detected even without cobalt. This could be linked to a leaky nature of the promoter rcn. However this activity is at least two times lower than the one obtained in presence of cobalt.


Conclusion

Our characterisation of rcn promoter shows that this promoter is inducible by cobalt. Kinetic analysis of the promoter allowed us to establish that an OD(600nm) of 0,2 was optimum for rcn promoter activation.

To conclude, this work shows that this promoter can be used with efficiency in a cobalt sensitive system.

Corroboring results of this characterisation can be seen on the main page of an other part characterisation, BBa_K540000.

Safety

This part is not toxic by itself. However, when using this part, you will probably need to handle cobalt. Cobalt is toxic in all its forms ( ionic or metallic ) by inhalation, ingestion or contact. Wear adapted personal protection equipment ( labcoat, safety glasses, safety gloves ) and dispose of it in appropriate waste containers.

Sequence and Features


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    INCOMPATIBLE WITH RFC[21]
    Illegal BglII site found at 47
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    COMPATIBLE WITH RFC[25]
  • 1000
    COMPATIBLE WITH RFC[1000]