Difference between revisions of "Collections/BIOFAB"

Revision as of 15:07, 21 August 2021

This collection is undergoing curation by the 2021 FSU iGEM team...

How is the BIOFAB collection useful to you?

The BIOFAB collection contains over 250 promoters that are registered BioBricks parts. The promoters have a range of relative expression that spans four orders of magnitude. Promoters of different strengths can be selected from the BIOFAB collection based on desired expression levels. This allows the promoter strength to be varied when designing genetic constructs by selecting a promoter with a different relative strength. The BIOFAB promoters do not always display the expected expression strength. The observed expression strength is thought to vary depending on the genetic context. To ensure that a promoter with the desired strength is selected, the design should be tested with several different promoters of similar strengths. Using multiple promoters increases the likelihood that at least one promoter will display the desired strength.

How does it work?

The promoters on this page are listed in order of decreasing strength. The strongest promoters produce the most RNA transcripts of their downstream gene, while the weakest promoters produce the fewest RNA transcripts. The promoter strength is determined by how strongly the DNA sequence recruits RNA polymerase. Stronger promoters are better able to recruit RNA polymerase, so they cause transcription to occur more frequently. Weaker promoters cannot recruit RNA polymerase as effectively, so they cause transcription to occur less frequently.

How was it built?

The 2018 FSU iGEM team measured the expression levels of three BIOFAB promoters in iGEM plasmids. A test device was created, which contained a BIOFAB promoter, a ribosome binding site (part B0034), a red fluorescent protein (part mRFP1 E1010), and a double terminator(part B0015). (make the names of these parts hyperlinks to their webpages) The test device was incorporated into the plasmid pSB1C3, which gives transformed bacteria resistance to chloramphenicol.

[plasmid map]

The test device was created by combining the pSB1C3 backbone with two overlapping DNA inserts. The first insert contained the biobrick prefix, the BIOFAB promoter, and part of the mRFP1 gene. The second insert contained the full mRFP1 gene, the double terminator, and the biobrick suffix. The three DNA sequences were then combined into one plasmid using the NEB Hifi DNA Assembly Master Mix protocol. This procedure combines multiple pieces of DNA that share overlapping sequences into a single DNA molecule. The partial mRFP1 sequence on the first insert overlaps with the full mRFP1 gene on the second insert, so the Hifi Assembly method combines the two inserts into a single DNA oligo. The combined insert begins with a biobrick prefix and ends with a biobrick suffix, which overlap with the prefix and suffix that are found on the plasmid. Once the insert is assembled into the plasmid, the final plasmid is complete.

Libraries

Modular Promoter Library

Randomized Promoter Library

Terminator Library

References

Mutalik, V., Guimaraes, J., Cambray, G. et al. Precise and reliable gene expression via standard transcription and translation initiation elements. Nat Methods 10, 354–360 (2013). https://doi.org/10.1038/nmeth.2404

The data visualization is provided by the Charts.css library. You can use the Charts.css 0.9.0 library in your wiki page by adding the FSU/ChartsCSS template to the page.

Tables Generated by the Parts Registry

Modular Promoters Table

Randomized Promoters Table

Terminators Table