Difference between revisions of "Part:BBa K1045010:Experience"

Revision as of 17:16, 17 October 2013

This experience page is provided so that any user may enter their experience using this part.
Please enter how you used this part and how it worked out.

Applications of BBa_K1045010

We used this part in our DarR reporter system BBa_K1045017. BBa_K1045010 seemed to have been functional as our characterization experiments of BBa_K1045017 suggested. In this system, gfp is placed under the control of the DarR operator BBa_K1045000. We saw that GFP expression was repressed when E. coli harbored a construct carrying a DarR expression unit with BBa_K1045010 as an RBS. The down-regulation of the GFP levels indicated that DarR seemed to have been expressed. These characerization experiments are described in a detailed way in the sections below.

Microscope data

For characterization, E. coli BL21 was transformed either with BBa_K1045017 or with BBa_K1045013 as a control. Both strains were grown in the abscence of c-di-AMP and subjected to fluorescence microscopy.

In BBa_K1045013, gfp is placed downstream of a strong promoter and the DarR operator. This vector does not encode for DarR. The strong fluorescence of the cells transformed with BBa_K1045013 (Fig. 1 top) indicated that GFP was expressed. However, when transformed with BBa_K1045017 (Fig. 1 bottom), the cells showed almost no fluorescence. In contrast to BBa_K1045013, BBa_K1045017 encodes for DarR. The low fluorescence suggested that DarR was expressed and active as a repressor down-regulating gfp transcription. Hence, the promoter BBa_K1045011 and the RBS BBa_K1045010 used for DarR expression seem to be functional.

Fig. 1.: Top: E. coli transformed with a plasmid encoding BBa_K1045013 shows a strong green fluorescence under the fluorescence microscope. Bottom: E. coli transformed with a plasmid harboring the DarR reporter system barely shows fluorescence.

Plate reader data

We furthermore produced quantitative data characterizing the growth and the fluorescence over time of the BL21 E. colis we transformed with the DarR reporter system construct BBa_K1045017. As a control, we used E. coli cells harboring the BBa_K1045013 plasmid. The following graphs show the results of the plate reader experiments performed to quantify the strength of the DarR construct in E. coli. Shown are growth curves measured at the wavelength 600 nm for the cell density (Fig. 2) and 509 nm for the GFP (Fig. 3), which is encoded in the construct. For each measurement, three technical and two biological replicates were done. The graphs show the mean value of the technical replicates and one of the biological replicates. As written in the legend, a dilution series of c-di-AMP was used to test the reaction of the DarR reporter system to the nucleotide. Experimental setup: total time 21 h; 15 min measurement interval; 37°C, medium shaking; 96-well titer plate; Synergy Mx Monochromator-Based Multi-Mode Microplate Reader; Gen5 V2.01

Fig. 2: Top: Growth curve of the cells with the DarR construct; Bottom: Growth curve of the GFP Control (Cells transformed with the reporter system, but without the repressor DarR).Please enlarge the pictures for better reading. (click on them)

Fig. 2: Top: Fluorescence curve of the cells with the riboswitch construct; Bottom: Fluorescence curve of the GFP Control. Please enlarge the pictures for better reading (click on them).

As in the microscope experiments described above, the expression of the reporter was prevented (even without c-di-AMP), when DarR was encoded in the vector. Hence, DarR seemed to be expressed via the regulatory parts BBa_K1045011 and BBa_K1045010.

User Reviews

UNIQ2bc35026ef11429c-partinfo-00000000-QINU UNIQ2bc35026ef11429c-partinfo-00000001-QINU