Difference between revisions of "Part:BBa K1065001"

Line 14: Line 14:
  
 
===Usage and Biology===
 
===Usage and Biology===
This enzyme was first purified  from <I>Pseudomonas Siringae</I> pv. <I>phaseolicola</I> PK2, a 2-oxoglutarate-dependent ethylene producing bacterium <a href="#ref1" id="ret_ref1">[1]</a>. <br/>  
+
<html>This enzyme was first purified  from <I>Pseudomonas Siringae</I> pv. <I>phaseolicola</I> PK2, a 2-oxoglutarate-dependent ethylene producing bacterium <a href="#ref1" id="ret_ref1">[1]</a>. <br/>
 +
</html>
  
 
<html>
 
<html>

Revision as of 18:58, 3 October 2013

AraC-pBAD + 2-oxoglutarate oxygenase/decarboxylase (EFE) + terminators

This device is composed by an AraC-pBAD promoter (BBa_K731201) + 2-oxoglutarate oxygenase/decarboxylase (BBa_K1065000) + terminators (BBa_B0015).

2-oxoglutarate oxygenase/decarboxylase is an Ethylene Forming Enzyme (EFE) that catalyzes Ethylene biosynthesis from 2-oxoglutarate.

Safety

This part produces Ethylene, a compound that is inflammable at a concentration ranging from 2.7% to 36%. We characterized this part under the control of an AraC-pBAD promoter. With an air volume/culture volume ratio of 4, about 200 ppm (0.02%) of Ethylene was detected by gas chromatography. This concentration is thus much lower than the inflammability threshold of Ethylene. However, we suggest to use this part carefully and to make all manipulations of open cultures under a chemical hood.


Usage and Biology

This enzyme was first purified from Pseudomonas Siringae pv. phaseolicola PK2, a 2-oxoglutarate-dependent ethylene producing bacterium [1].

The enzyme was thoroughly studied by many research groups. It was purified and characterized using an in vitro test [2]. It was then transformed and ectopically expressed in E.coli [3] and in Synecocystis sp [4].

EFE characterization in Neb10bβ cells

Figure 1 Effect of EFE on cell growth. Cell density was measured at different time points to determine the effect of EFE expression. Neb10β cells were grown at 37 °C in LB until an OD of 0.6. The cultures were then split in four samples of equal volume, and two samples were induced with 5 mM Arabinose. Induced samples show a slowed growth rate. This was expected as 5mM arabinose is considered a strong induction that causes moderate stress on cells.

Ethylene detection through Micro Gas-Chromatography


Figure 2 Ethylene detection using an Agilent 3000 Micro GC set up with a plot U column. Neb10β cells were grown until an OD of 0.5. The culture was then split in two samples of equal volume (3 ml) and placed into an hermetically closed vial with a septum and a rubber cap. One of the two samples was induced with 5 mM arabinose. The vials were kept at 37°C under shaking for 4 hours. The vials were then connected to the Micro GC and measurements were performed. Panel A: induced 1.5 ml sample (green curve) and 3 ml sample (red curve) showed a characteristic peak corresponding to Ethylene. On the other hand, the 3 ml non-induced sample (blue curve) didn't show the Ethylene peak. Ethylene concentration was estimated to be 61 ± 15 ppm for the 1.5 ml culture and 101 ± 15 ppm for the 3 ml culture. Panel B: picture of the vial connected to the micro GC.

Kinetic assay for Ethylene production

Figure 3 Kinetic assay for Ethylene production. Neb10β cells were grown in agitation on a thermostatic block at 37 °C until an OD of 0.5 - 0.8 and then connected to the Micro GC. Every 45-60 min a measure was taken for a total experiment time of about 8 hours. Samples were induced at two different OD and this had a marked effect on the amount of Ethylene produced. However, it seems that the Ethylene concentration in the air volume reached saturation after only two hours. The red dashed line indicates the amount of Ethylene detected with a culture left in the shaking incubator for the entire duration of the experiment and subjected to only one measurement. As expected, an higher concentration of Ethylene was measured due to the minimal gas loss using this approach.

Acceleration of fruit ripening

This device was used for accelerating fruit ripening. Many types of fruit were tested and ripened successfully. For more information and details please visit the UNITN wiki page .

Figure 4 Acceleration of fruit ripening. Panel A: our system was applied to the acceleration of fruit ripening. We designed hermetically closed jars with a rubber hose connector. These jars contained our test-fruit and each one was connected to a flask. The flasks contained 300 ml of induced (or non-induced) culture at an OD of 0.8. The flasks contained cultures were maintained at 37°C using a laboratory heating plate with a magnetic stirrer. During four to six days, cultures were substituted on a daily basis with a new induced (or non-induced) culture. Furthermore, non-modified jars (i.e. with no connector) were used for the negative control fruit samples (no cells sample). Panel B: ripening of plums. Plums exposed to Ethylene show a more advanced stage of ripening after 4 days of treatment respect to the negative controls (no cells and non- induced BBa_K1065001).

Sequence and Features


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    INCOMPATIBLE WITH RFC[21]
    Illegal BglII site found at 1530
    Illegal BamHI site found at 1144
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    INCOMPATIBLE WITH RFC[25]
    Illegal NgoMIV site found at 1228
    Illegal AgeI site found at 979
    Illegal AgeI site found at 2281
  • 1000
    INCOMPATIBLE WITH RFC[1000]
    Illegal SapI site found at 961