Difference between revisions of "Part:BBa K1139201"
Line 33: | Line 33: | ||
The result of our model is shown in Fig. 5.<br> | The result of our model is shown in Fig. 5.<br> | ||
− | [[Image:titech2013_parts_K1139201_main_Fig5.jpg|thumb| | + | [[Image:titech2013_parts_K1139201_main_Fig5.jpg|thumb|none|300px|<b>Fig. 5.</b> Result of our mathematical model]] |
For more information, see [http://2013.igem.org/Team:Tokyo_Tech/Experiment/RM-lac_Hybrid_Promoter_Assay our work in Tokyo_Tech 2013 wiki]. | For more information, see [http://2013.igem.org/Team:Tokyo_Tech/Experiment/RM-lac_Hybrid_Promoter_Assay our work in Tokyo_Tech 2013 wiki]. |
Revision as of 05:49, 27 September 2013
PphoA-GFP-TT
PphoA is a promoter that is activated by PhoB-phosphorylated when phosphate concentration is low. GFP is a reporter.
We constructed this part by ligating phoA promoter (BBa_K1139200) to the upstream of promoterless GFP generator (BBa_I751310).
We improved a phosphate sensor part since the existing phosphate sensor part (OUC-China 2012, BBa_K737024) did not have sufficient data. We constructed this part by amplifying the phoA promoter region of E. coli (MG1655) and ligating it upstream of GFP part (Fig. 1). This phoA promoter is the inducible promoter of the alkaline phosphatase gene (phoA) from E. coli (M. Dollard et al., 2003). This promoter is repressed by high concentration phosphate (H. Shinagawa et al., 1983, Y. Hsieh et al., 2010) (Fig. 2).
By an induction assay, this part was confirmed to be repressed by the increase in phosphate concentration.
Compared to OUC-China’s phosphate sensor part including phoB promoter (Fig. 3).
From our results explained above, we determined parameters for the induction mechanism. By fitting the results to the following Hill equation (Fig. 4), we identified K and the hill coefficient. Those parameters (Tab. 1) will be used in our future modeling. Plants are reported to be in phosphate starvation under the concentration of 1 mM (D. Hoagland et al., 1950). Our part can also sense the concentration below 1 mM (Fig. 5). Therefore, our improved part is useful for our farming circuit. We also identified maximum GFP production rate in this construct.
We set the parameters as follows:
Parameter | Value |
α | 720 |
β | 3.3 |
m | 190 |
The result of our model is shown in Fig. 5.
For more information, see [http://2013.igem.org/Team:Tokyo_Tech/Experiment/RM-lac_Hybrid_Promoter_Assay our work in Tokyo_Tech 2013 wiki].
Sequence and Features
- 10COMPATIBLE WITH RFC[10]
- 12COMPATIBLE WITH RFC[12]
- 21COMPATIBLE WITH RFC[21]
- 23COMPATIBLE WITH RFC[23]
- 25COMPATIBLE WITH RFC[25]
- 1000INCOMPATIBLE WITH RFC[1000]Illegal BsaI.rc site found at 754