Difference between revisions of "Part:BBa K551001"

Revision as of 16:46, 21 September 2011

plasmid of insertion and deletion

The pINDEL plasmid is composed of 2 functional units:

1. the IN function which is composed of the gam, exo and bet genes coding for the lambda Red recombinase system
2. the DEL function which is based on the flp gene encoding the FLP site-specific recombinase and expressed at 42°C

Another feature of pINDEL is that its replication origin is not functional at 42°C due to the thermosensitivity of the RepA101Ts protein. This protein initiates replication at the ori site in permissive conditions (30°C) and is inactive at 42°C.

The deletion function and the thermosensitivity of the plasmid both could be shown to be working as intended (see functional parameters). The insertion function couldn't be properly tested.

Usage and Biology

The use of pINDEL is quite easy, you can check our visual how to manual here Media:Pindel-How-To.pdf

Sequence and Features

Functional Parameters

Thermosensitivity

We performed a thermal sensitivity experiment in liquid medium in which we measured the plasmid loss frequency as a function of time of culture at 42°C. We compared the viability (CFU/ml: colony forming units per ml of culture) of MC1061/pIN grown at 30°C and 42°C and plated on LB and LB Amp medium. If the plasmid is lost, then the bacteria won't grow on the LB Amp medium plates.

The MC1061 strain containing the pIN plasmid was grown in LB medium at 30°C (blue triangle) and 42°C (red square). At times indicated in the figure, a sample of the cultures was diluted and plated on LB and LB Amp plates as described in Materials and Methods. Colonies were counted after ON incubation at 30°C. The percentage of bacteria containing pIN is the ratio between the CFU/ml on LB Amp plates and the CFU/ml on LB plates multiplied by 100

This shows that the replication of pIN is impaired at 42°C. After 150 min of culture at 42°C, 60% of the bacteria have lost the pIN plasmid. After 275 min, only a very small proportion of bacteria retained the pIN plasmid (< 10%). Note that at time 0 of the experiment, around 70% of the bacteria retained the pIN plasmid suggesting that the repA101ts origin is not fully active even at 30°C. With time, the pIN plasmid is maintained in about 80% of the bacteria at 30°C. This experiment was performed only once due to time limitations and should be repeated to confirm the data.

Deletion function

To test the deletion capacity of the pINDEL plasmid, we transformed pINDEL and pIN in the MG1655 ∆tldD ::frt-cm-frt strain and the transformants were selected on LB Amp Cm medium at 30°C. Four independant colonies containing pIN or pINDEL were streaked on LB plates and were incubated ON at 42°C to lose plasmids and to express the flipase. For each independant transformants streaked we stabbed 8 colonies on LB and LB Cm plates.

All 32 candidates that contained pIN grew on LB plates and LB Cm plates indicating that none of them has lost the antibiotic resistance cassette. All 32 candidates that contained pINDEL grew on LB but none of them grew on LB Cm plates indicating that all of them have lost the antibiotic resistance cassette.

This gives us a 100% success rate for excision.

Growth

In order to test if the leak of promoter λpR of flippase or the expression of Red genes affects bacterial growth we measured OD600nm of growing MC1061 strain containing pIN or pINDEL.

These bacteria were cultivated overnight at 30°C in LB and in LB with 1% arabinose. The overnight cultures were diluted at an OD600nm of 0.01 in the same medium and incubated at 30°C with shaking. The OD600nm was measured every 30 minutes.

MC1061-pIN (square) and MC1061-pINDEL(triangle) were cultivated overnight at 30°C in LB Amp (green) and LB with 1% arabinose (red). The overnight cultures were diluted at an OD600nm of 0.01 in the same medium and incubated at 30°C with shaking. The OD600nm was measured every 30 minutes

This shows that strains containing the pIN plasmid or the pINDEL plasmid have more or less the same growth rate in the same medium indicating that the leak of the flippase promoter has few (or no) effect on bacterial growth.

However when arabinose was added to the medium growth rate of both strains is affected indicating that Red genes expression has a detrimental effect on bacterial growth.