Difference between revisions of "Part:BBa K2972008"

Line 6: Line 6:
 
This part is used to test the sensitivity of QS system.<br>
 
This part is used to test the sensitivity of QS system.<br>
 
To discover the relationship between the components produced by the QS system and the density of cells in the process of cell growth. We obtained the curve of fluorescence intensity changing with time under different promoters which inducing LuxR expression according to experiments.
 
To discover the relationship between the components produced by the QS system and the density of cells in the process of cell growth. We obtained the curve of fluorescence intensity changing with time under different promoters which inducing LuxR expression according to experiments.
[[File:T--BIT-China--model-2-i1.png|500px|thumb|center|<b>Fig.the curve of fluorescence intensity changing with time under different promoters<\b>]]
+
[[File:File:BIT-China gold1.png|500px|thumb|center|<b>Fig.the curve of fluorescence intensity changing with time under different promoters<\b>]]
 
===Modeling===
 
===Modeling===
 
When considering the change of signal factor concentration in a single cell, we refer to the model of Maike in 2010. Because our model is in a closed container, we delete the diffusion term from the original model, and improve the solvability. We modified and established our own model according to the actual situation.
 
When considering the change of signal factor concentration in a single cell, we refer to the model of Maike in 2010. Because our model is in a closed container, we delete the diffusion term from the original model, and improve the solvability. We modified and established our own model according to the actual situation.

Revision as of 21:41, 21 October 2019


Quorum sensing(QS) sensitivity test

Introduction

This part is used to test the sensitivity of QS system.
To discover the relationship between the components produced by the QS system and the density of cells in the process of cell growth. We obtained the curve of fluorescence intensity changing with time under different promoters which inducing LuxR expression according to experiments.

File:File:BIT-China gold1.png
Fig.the curve of fluorescence intensity changing with time under different promoters<\b>

Modeling

When considering the change of signal factor concentration in a single cell, we refer to the model of Maike in 2010. Because our model is in a closed container, we delete the diffusion term from the original model, and improve the solvability. We modified and established our own model according to the actual situation.


BIT-China Modeling3.jpg BIT-China Modeling4.jpg

Result

In this result, we can clearly see that AHL showed very low growth rate in the earlystage. At a certain time, when the population density reached a certain threshold,AHL showed a sharp increase trend, indicating that quorum sensing has occurred. The growth rate of LuxI also began to increase suddenly, and a large number of products were produced. This result shows that our model is very consistent with the phenomenon of quorum sensing, and can be used as a mathematical description of the cell growth state in the experiment. This model can be great significance to the experimental guidance.

Experiment

QS system verification experiment
The production of seed fermentation broth:The sequenced strains were transferred to petri dishes and activated(The strain information is shown in table 1),Then we transferred the activated strain to a single colony in LB medium containing 0.1% Amp. Shake flask fermentation :

  • Add 20ml LB medium containing 0.1%Amp into 50ml conical flask
  • Measure seed fermentation broth concentration with an ultraviolet spectrophotometer
  • Transfer the seed fermentation broth to 20mlLB medium(0.1%Amp),when the OD600.is0.05Abs
  • Culture in shaking table for 12h, sampling every 2 hours

Fluorescence values and OD600 data at the excitation wavelength of 480nm and emission wavelength of 517nm were measured and the results were as follows:


Result analysis

Because the strain transferred from the seed fermentation broth to the conical flask has turned on the QS system and the green fluorescence has been expressed, we took the initial fluorescence value after culture for four hours.As can be seen from figure 1, with the passage of fermentation time, the green fluorescence value gradually increased, and the QS system of the strain was turned on. However, after two hours of opening, excessive quorum sensing signals inhibited the pLUX promoter, leading to the gradual shutdown of the QS system.The low expression of the strong promoter J23102 in the QS strain of green fluorescent protein indirectly indicates that quorum sensing signal molecules have negative effects on the QS system. With the decrease of quorum sensing semaphore, pLUX can be turned on normally to realize the expression of green fluorescent protein. After 10 hours of culture, fluorescence was no longer significantly increased or decreased. Maybe the nutrient content in the culture medium was too low, which affected the growth of escherichia coli, and the population density would not increase too much.The 12h growth curve is shown in figure 2.


Gold medal part improvement

According to the description of promoter strength provided by the official website of IGEM, we conducted different strength promoter replacement experiments for QS quorum sensing circuit.We investigated the effects of different LuxR contents on QS system and the growth of bacteria.The results showed that promoter J23102 with high intensity was not sensitive to the population density of e. coli..Although J23102 can realize the opening of QS population density induction circuit, the promoter J23117 with the weakest expression intensity is more suitable for the opening of QS population density system in e. coli.At the same time, the change of different promoters indicated that LuxR would not affect the growth of e. coli to some extent.




Sequence and Features


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    INCOMPATIBLE WITH RFC[21]
    Illegal BglII site found at 2359
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    COMPATIBLE WITH RFC[25]
  • 1000
    INCOMPATIBLE WITH RFC[1000]
    Illegal BsaI.rc site found at 1634