Difference between revisions of "Part:BBa K1139201:Experience"

Latest revision as of 21:03, 28 October 2013

PphoA-GFP-TT

Materials and Methods

1. Construction
-pSB6A1-Ptet-GFP (MG1655)… positive control
-pSB6A1-ΔP-GFP (MG1655)… negative control
-pSB6A1-PphoA-GFP (MG1655)…BBa_K1139201

The phoA promoter region of E. coli was amplified from MG1655 genomic DNA by PCR using upstream primer (5’-acgtgaattcgcggccgcttctagagaaagttaatcttttcaacagctgtcataaag-3’) and downstream primer (5’-ccgctactagtaaatacattaaaaaataaaaacaaagcgactataagtctc-3’). Amplification was carried out with the steps shown in Fig. 1.

Fig. 1. Steps for PCR of the phoA promoter

2. Assay Protocol

• 2-0. Prepare MOPS minimal medium as follows (Neidhardt et al., 1974).
  

Also, prepare a series of phosphate concentration gradient 1X MOPS by changing the volume of K₂HPO₄ (We prepared the series as 0, 10, 30, 50, 100, 150, 200, 250, 300, 500, 1000 µM).

[ Prepare MOPS minimal medium ]
200 mL of 1X MOPS is prepared as follows.

1. Mix ingredients above and adjust the pH to 7.2 with 5 M NaOH.
2. Filter sterilize. It can be stored at 4°C, for up to 1 month.
3. Before use, add carbon source (we used a final concentration of 0.1% glucose).

[ 10X MOPS mixture (200 mL) ]
1. Add the following to ~60 mL milliQ H₂O:

2. Add 5 M KOH to a final pH of 7.4
3. Bring total volume to 88 mL
4. Make fresh FeSO₄ solution and add it to the MOPS/Tricine solution:

5. Add the following solutions to the MOPS/Tricine/FeSO₄ solution
(Mix in the order shown)

6. Filter sterilize with 0.2 micron filter
7. Aliquot into sterile plastic bottle and freeze at -20°C.

[ Micronutrient stock (50 mL) ]
Mix everything together in 40 mL autoclaved milliQ H₂O, bring up total volume to 50 mL.
Store at room temperature.

• 2-1. Prepare overnight cultures of BBa_K1139201, positive control and negative control, each in MOPS medium (including 1.32 mM K₂HPO₄) containing ampicillin (50 µg/mL) at 37°C.
  
• 2-2. Dilute the overnight cultures to an OD600 of 0.1 in fresh MOPS medium (3 mL) containing ampicillin (50 µg/mL). (→fresh cultures)
  
• 2-3. Incubate the fresh cultures until the observed OD600 reaches 0.4-0.6.
  
• 2-4. Centrifuge the cells at 6,000g, 25°C, 10 minutes. Wash twice with MOPS minimal medium without phosphate containing ampicillin (50 µg/mL). Then suspend the cells in the same medium to obtain a final OD600 of 10.
  
• 2-5. Add 300 µL of prepared cell suspension to 2.7 mL of test solution, the series of phosphate concentration gradient 1X MOPS, containing ampicillin (50 µg/mL)
  
• 2-6. Incubate the cells for 140 minutes at 26°C.
  
• 2-7. 1 mL of each culture was harvested by centrifugation and suspended by adding 1 mL of PBS (phosphate-buffered saline). Dilute the suspension to obtain a final OD600 of around 0.2 by PBS.
  
• 2-8. Dispense 600 µL of each suspension into a disposable tube through a cell strainer. Fluorescence intensity was measured with a flow cytometer of Becton, Dickinson and Company.
  

Results

1. Before inducing by phosphate concentration
Fig. 2.1 shows the fluorescence intensity of the fresh cultures (the MOPS medium which contains 1.32 mM K₂HPO₄) incubated until the observed OD600 reached 0.4-0.6 (Assay protocol 1-2-3). The phoA promoter was repressed because the MOPS medium contained 1.32 mM phosphate, which was a high concentration for phoA promoter.

Fig. 2.1. Fluorescence intensity of the fresh cultures

2. After inducing by phosphate concentration
Fig. 2-2 and Fig. 2-3 show the fluorescence intensity of the induced cells by phosphate concentration. In Fig. 2-2, we saw that the phoA promoter was repressed by high phosphate concentrations, while the constitutive promoter did not show any significant change. Fig. 2-3 also proved that the increase in phosphate concentration repressed the phoA promoter. Fig. 2-4 shows the picture of fluorescence of the induced cells. Especially, we confirmed that the phoA promoter was drastically repressed at phosphate concentrations of 100 to 200 µM.

Fig. 2-2. Fluorescence intensity of the induced cells (with positive and negative controls)

Fig. 2-3. Fluorescence intensity of the induced cells of BBa_K1139201

Fig. 2-4. Picture of fluorescence of the induced cells

Discussion

We confirmed that the increase in phosphate concentration repressed the phoA promoter and succeeded in improving the phosphate sensor part. Though OUC-China 2012 reported a phosphate sensor part including the phoB promoter (BBa_K737024), their part did not have sufficient data for us. Their assay data (Fig. 3-1, converted to bar chart) did not show significant change in RFU (relative fluorescent unit) in response to phosphate concentrations. The positive and the negative control were not shown. Their references for constructing and assaying the part were not clear, either. In addition, we found some mutations (substitution and deletion) in their part through analyzing the DNA sequence (Fig. 3-2).

Fig. 3-1. OUC-China 2012's phoB promoter assay result reported by them (converted to bar chart)

Fig. 3-2. Mutations found in OUC-China's phosphate sensor part

We assayed OUC-China's phosphate sensor part by the same method as that for our phoA promoter assay since we thought that the phoB promoter should also be repressed by high phosphate concentrations. According to previous reports, the regulation of the phoB promoter is similar to that of the phoA promoter (Shinagawa et al., 1983). The result of this assay (Fig. 3-4, enlarged view in Fig. 3-5) shows clearly that their part did not respond to the increase in phosphate concentration compared to our part including the phoA promoter (Fig. 3-3). Therefore, we hypothesize that the mutations have something to do with the activity of the phoB promoter. Thus, we conclude that we improved the phosphate sensor part. Our part can be useful not only for our project but also for various studies in synthetic biology.

• 

  Fig. 3-3. Our induction assay result for our phoA promoter

• 

  Fig. 3-4. Our induction assay result for OUC-China 2012's phoB promoter

Fig. 3-5. Enlarged view of Fig. 3-4

For more information, see [http://2013.igem.org/Team:Tokyo_Tech/Experiment/phoA_Promoter_Assay our work in Tokyo_Tech 2013 wiki].

Applications of BBa_K1139201

User Reviews

UNIQ21f1db3718abbaed-partinfo-00000006-QINU UNIQ21f1db3718abbaed-partinfo-00000007-QINU